Where is the neutral safety switch on a jeep?
The 60’s and 70’s GM cars had the neutral safety switch under the dash, on top of the steering column, out of the elements, high and dry. They usually would last forever. The Jeep ones are tucked up on the outside of the trans, exposed to rain, snow, salt, and guess what, they fail. HHHHMMM, sounds like a design flaw to me.
How to test and replace the neutral safety swtich?
Check with your vehicle’s repair manual for testing parameters. And don’t forget to wear safety glasses. The inhibitor switch detects the selector position and sends a signal to the A/T control unit. P0705 is a malfunction detected when the A/T control unit does not receive the correct voltage signal from the switch based on the gear position.
Where is the NS switch on a Jeep Cherokee?
The NS switch is tucked up tight against the top side of the tranny, and I don’t know, myself which wires are which. If you could find that out, then you could hook the correct two wires together, and it would be bypassed. You’d need a schematic of the switch to know which 2 wires to cut and connect.
Where is the ignition switch on a Jeep Cherokee?
When things are working as they should, when you turn the key to start, the ignition switch sends a 12 volt/low current signal down to the small electrical terminal on the starter solenoid, which is on the starter itself, on the top.
Where is the neutral safety switch on a 1998 Jeep Cherokee?
1998 jeep cherokee: the neutral safety switch located 1998 jeep cherokee: the neutral safety switch located – Answered by a verified Jeep Mechanic We use cookies to give you the best possible experience on our website.
Can a Jeep Cherokee have a NSS switch?
A Jeep Cherokee with a manual transmission does not have a NSS. Keep in mind that some symptoms of the NSS failing are: Need To buy Parts? Get them cheaper Here: http://www.bleepinjeep.com/discounts *Disclaimer – This product is meant for entertainment purposes only. Your mileage may vary. Do not try this at home. Void where prohibited.
When things are working as they should, when you turn the key to start, the ignition switch sends a 12 volt/low current signal down to the small electrical terminal on the starter solenoid, which is on the starter itself, on the top.
What to do when your Jeep Cherokee won’t start?
NOw, when your Jeep won’t start, turn the key to the on position, hit your little horn button, it will activate the starter solenoid, which in turn cranks the starter, and lo and behold, the engine starts, it works GREAT!!