Where is the jack point on a Toyota Corolla?
The Toyota Corolla has a series of notches below the front and rear doors on both sides. These are the designated lifting points. The jack needs to go into the notch nearest the wheel to be lifted.
Where is the jack stand on a 2009 Toyota Corolla?
The Jack Stands should be placed on the sides of the vehicle behind the front tires where the jacking tabs are located. This is the same place you would jack your car up using the OEM jack.
Where is the Jack on a Toyota Corolla?
The Toyota Corolla has a series of notches below the front and rear doors on both sides. These are the designated lifting points. The jack needs to go into the notch nearest the wheel to be lifted. Raise the Corolla with the jack. Slide a jack stand under the frame and lower the car onto the stand. Remove the jack.
Where are the lifting points on a Toyota Corolla?
These points are designated in your owner’s manual, usually in the section on replacing a flat tire. The Toyota Corolla has a series of notches below the front and rear doors on both sides. These are the designated lifting points. The jack needs to go into the notch nearest the wheel to be lifted.
How do you lift a Toyota Corolla off the ground?
The jack needs to go into the notch nearest the wheel to be lifted. Raise the Corolla with the jack. Slide a jack stand under the frame and lower the car onto the stand. Remove the jack. Repeat the process for each wheel until you have all four wheels off the ground and securely positioned on the jack stands.
Can a Toyota Corolla fall off the floor?
Make sure to set the protrusion on the jack attachment properly into the hole of the jack point. Raising the vehicle with an improperly positioned floor jack will damage the vehicle and may cause the vehicle to fall off the floor jack.
How to position the floor jack on a Toyota Corolla?
Improper placement may damage your vehicle or cause injury. 1 Take out the jack attachment. 2 Set the jack attachment on the floor jack and position the jack. 3 Before raising the vehicle, make sure that the floor jack is positioned so that the protrusion on the jack attachment fits securely into the hole of the jack point.
Make sure to set the protrusion on the jack attachment properly into the hole of the jack point. Raising the vehicle with an improperly positioned floor jack will damage the vehicle and may cause the vehicle to fall off the floor jack.
How to put a floor jack on a car?
2 Set the jack attachment on the floor jack and position the jack. 3 Before raising the vehicle, make sure that the floor jack is positioned so that the protrusion on the jack attachment fits securely into the hole of the jack point. Make sure to set the protrusion on the jack attachment properly into the hole of the jack point.
How to set up Bluetooth on a Toyota Corolla?
If more than 1 Bluetooth® device has been registered, select which device to connect to. 1 Press the “SETUP” button. 2 Select “Bluetooth*”. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. 3 Sele