Where is the inlet filter system on a Bell Helicopter?
INSTRUCTIONS FOR CONTINUED AIRWORTHINESS INLET BARRIER FILTER SYSTEM for the Bell Helicopter Textron Canada Limited Model 407 Helicopters FAA STC No. SR09368RC 17891 Chesterfield Airport Rd. Chesterfield, MO 63005 AFS-BH407-IBF-KIT-ICA Aerospace Filtration Systems, Inc. Revision: G Proprietary Information
What kind of filter does a Bell 407 helicopter use?
Effectivity for this ICA is for all Bell model 407 helicopters with the Aerospace Filtration Systems, Inc. (AFS) Inlet Barrier Filter (IBF) System installed and/or the optional (AFS) Inducer Vent Filter (IVF) System installed. AFS-BH407-IBF-KIT-ICA Aerospace Filtration Systems, Inc. Revision: G Proprietary Information
What is the abbreviation for inlet barrier filter system?
AFS-BH407-IBF-KIT-ICA Aerospace Filtration Systems, Inc. Revision: G Proprietary Information Use or disclosure of this material is subject ivAFS Bell 407 IBF to the restrictions on the title page Instructions for Continued Airworthiness PROPRIETARY DATA STATEMENT
Is the effectivity of inlet filter system proprietary?
These data, excluding Chapter 4, Airworthiness Limitations, are proprietary to Aerospace Filtration Systems, Inc. Disclosure, reproduction, or use of these data for any purpose other than helicopter operation and/or maintenance is forbidden without prior written authorization from Aerospace Filtration Systems, Inc. EFFECTIVITY
How is the bell housing connected to the atmosphere?
During normal operation, the bell housing is connected to the atmosphere through the threaded drain hole in the bottom. This allows the bell housing, transmission and transfer case to vent to the atmosphere. For fording operations the operator installs a plug in the bell housing drain hole to seal it.
What kind of air filter housing do I Need?
TUPARTS Engine Air Filter Box Plastic Housing Assembly fit for 2007 2008 for LEXUS RX350 2008 2009 2010 2011 2012 for Toyota Highfor Lander 2007 2008 2009 2010 for Toyota Sienna Automotive Replacement . . Only 13 left in stock – order soon.
Is the bell housing on an M38 pressurized?
M38s after Engineserial number 74419 had a sealed bell housing. The bell housing, transmission, and transfer case were pressurized while fording. I will refer to this as the Latesystem.