Where is the headlight relay on a Ford Ranger?
The Ford Ranger headlight relay location is in the fuse panel under the hood.
How do you turn the headlights on a Ford Ranger?
To turn on the headlights on a ford ranger, look to the left of the steering wheel, just below the air vent. There is a dial with indication for off, parking lights, and headlights.
Where is the fuse box on a Ford Ranger?
The fuse panel is located on the left-hand side of the instrument panel facing the driver’s side door.
How do you reset the BCM on a Ford Ranger?
Disconnect the negative battery terminal for 5 minutes then reconnect in order to reset the body control module.
Is there a fuse for the headlights?
Most headlight systems are going to involve a fuse, switch, relay, and bulb. This relay is the connection between the battery of your car and your headlights. There are also fuses involved to protect the rest of your electrical system should there be a shortage.
How do you check a headlight switch?
Turn the switch to the parking lights setting and observe the meter. You should see zero or no more than a few Ohms of resistance. Move the negative lead to the output wire for the headlight relay, then turn the switch to the headlights setting and check the meter.
How do you change a headlight on a 1993 Ford Ranger?
Replacing the headlight switch on 1993 and 1994 Ford Rangers follows the same steps.
- Remove the negative battery cable from the battery.
- Open the ashtray, push the connector latch down and pull out the ashtray.
- Use a socket wrench to unscrew the instrument panel screws.
- Pull the headlight switch out as far as it goes.
How do you turn on a Ford headlight?
How to Turn on the Headlights on a Ford Focus
- Sit in the driver’s seat and locate the headlight control knob on the left side of the steering wheel.
- Turn the headlight control knob clockwise two positions to turn on the headlights.
Why are the headlights on my Ford Ranger not working?
Check your headlight operation. Crank the engine, turn on the headlights and stand in front of your Ranger to determine which headlights are nonfunctional. If your headlights work but flicker, you likely have a faulty headlight switch or a wiring problem. This will require professional repair.
Why are the headlights on my car not working?
If your headlights work but flicker, you likely have a faulty headlight switch or a wiring problem. This will require professional repair. If only one of your headlights is nonfunctional, you probably have a faulty bulb or relay. Turn on your high-beam (“bright lights”) headlights to check their operation.
How many headlight relays does a Ford Ranger have?
Most Ford Rangers contain two headlight relays: one for the high-beam and one for the low-beam. Use your engine-bay fuse box as a guide; relay type and location will depend on the year model and engine size.
How to troubleshoot headlight bulbs on a Ford?
Inspect the bulbs. Remove the bulb sockets from the rear of your headlight assembly and inspect their filament. If the bulb is bad, the filament will be broken; if it’s good, the filament will be connected. Check your high-beam and low-beam bulbs. Replace the bulbs if necessary.