Where is the drain tube on a Honda Accord?
The drain tube is located underneath the glove box compartment. It is a black rubber hose in between two bolts. Tightly grip the hose, and pull it towards you. It should come straight out. Figure 3. Location of the evaporator drain tube. Figure 4. A removed drain tube.
How does the a / C system in a Honda Accord work?
Your A/C may not be in the best shape to perform. As air runs through a series of tubes and components of the A/C system, the evaporator removes hot air from inside the cabin to turn it into frigid, cool air. During that process, the evaporator also produces condensation, which is then dripped through a tube and released underneath the car.
Where is the evaporator located on a Honda Accord?
The evaporator is located beneath the glove box, so this procedure will take place in the passenger’s side area. Slide the seat as far back as it will go, and lay down a towel to protect your carpeting from getting wet. To assemble the vacuum, insert a 5/16 rubber hose into the end of the vacuum’s hose.
How do you unclog an A / C unit in a Honda Accord?
Connect the drain tube hose to the vacuum. Disconnect the vacuum hose from the drain tube. Start your car, and let it run for a couple minutes. Finally, turn on your A/C to make sure that cold air is coming out. Figure 6. The unclogged evaporator may leak water.
Where is the AC plug on a Honda Accord?
The owner’s manual will direct you to the location of the AC system in your Honda Accord. The low pressure plug, will have the letter L embossed on it, remove that plug and set aside for reinsertion. Figure 2. AC system under your hood. Then set the air conditioning to maximum power and lowest temperature possible. Figure 3.
The drain tube is located underneath the glove box compartment. It is a black rubber hose in between two bolts. Tightly grip the hose, and pull it towards you. It should come straight out. Figure 3. Location of the evaporator drain tube. Figure 4. A removed drain tube.
The owner’s manual will direct you to the location of the AC system in your Honda Accord. The low pressure plug, will have the letter L embossed on it, remove that plug and set aside for reinsertion. Figure 2. AC system under your hood. Then set the air conditioning to maximum power and lowest temperature possible. Figure 3.
Connect the drain tube hose to the vacuum. Disconnect the vacuum hose from the drain tube. Start your car, and let it run for a couple minutes. Finally, turn on your A/C to make sure that cold air is coming out. Figure 6. The unclogged evaporator may leak water.
Where is the drain hose on an accord evaporator?
That drain hose is situated at the bottom of the evaporator case, so all the condensation (ideally) should run out. Your hose may be just hitting the evap core itself or a styrofoam liner (not sure how far you are trying to poke it in there). I haven’t taken my Accord case apart but I used to design aftermarket evaporators.