Where is the Crank Sensor located in a 2004 Nissan Maxima?
The crank sensor is located at the bottom center of the engine just below the flywheel area.
How to know if your engine has no spark?
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.
Why is my crank and cam sensor not working?
If it is giving a signal, then the cam and crank signals are way off and causing the wrong ignition timing. If you need to have a local expert come check this problem for you, a certified technician from YourMechanic can come to your car’s location to diagnose the hard starting issue and pinpoint the correct fix.
Why does my car not start when I crank the engine?
The crankshaft position (CKP) sensor monitors the position or rotational speed of the crankshaft. If the crankshaft position sensor has failed completely, and isn’t sending a signal to the (ECU) at all, then the computer won’t send any fuel to the injectors. This will leave you unable to start the car.
What causes a car to stall with no spark?
Consequently, An old or failing ignition pickup may cut out signal intermittently, which may cause the engine to stall. The engine may suddenly just shut off, almost as if the key had been turned off. Depending on the nature of the issue, sometimes the vehicle can be restarted and driven.
Why does my Nissan Altima have no spark?
I am now pushing a 2005 Altima with 2.5l because it will spin over but fails to start. No codes show on my snap-on scanner. It has no spark, the tack does not move. We changed the crank sensor, and no change. My scanner said that it should have 5 vdc on one pin of the connector and that the sensor should ohm out at 165 to 200 ohms.
Why does my car not start with a new crankshaft sensor?
A new crankshaft sensor should not have prevented the vehicle from starting. The cause of the no start issue is either related to a fuel or ignition issue that the vehicle has or something that happened during the replacement of the crank sensor.
Why does my Nissan club have no spark?
It has no spark, the tack does not move. We changed the crank sensor, and no change. My scanner said that it should have 5 vdc on one pin of the connector and that the sensor should ohm out at 165 to 200 ohms. When I tested the plug I had 12 vdc and the sensor reads open across all the pins. Did you rebuild the motor? did it die when driving.
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.