Where is the coolant reservoir on a Jeep Cherokee?
The video above shows you where the coolant reservoir in your Cherokee is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Jeeps, it will typically be in a section titled Fluid Capacities in the back of your manual.
How do you add Freon to a Jeep Grand Cherokee?
How to add freon to your 2012 Jeep Grand Cherokee: hook up the can of refrigerant (likely r-134a) to the low pressure port. When your compressor kicks on, add freon to the correct pressure. In addition to cooling, freon lubricates the compressor when it runs.
How to cool down a Jeep Cherokee engine?
With engine off, remove the temperature sender’s lead and loosen sender until coolant begins to flow out and no more air comes out. Keep an eye on the coolant bottle level. Tighten sender back up and reattach the leads. Top off coolant bottle with 50/50 antifreeze/water mix. Remember! Do this with the engine COOLED DOWN!
How to add coolant to a Jeep Liberty?
Be sure to check your owners manual to determine the correct type of fluid to add – for Jeeps, it will typically be in a section titled Fluid Capacities in the back of your manual. Mix the coolant with distilled water so that you have a combination of 50% coolant and 50% water.
Where do you fill the coolant on a Jeep Cherokee?
It is aXXXXXpioneer. Jeep Mechanic: hauto, Technician replied 11 years ago you can either fill directly into the radiator, wait the the engine is cold, remove the radiator cap and ad coolant. or you can ad to the coolant reservoir see picture below Ask Your Own Jeep Question
With engine off, remove the temperature sender’s lead and loosen sender until coolant begins to flow out and no more air comes out. Keep an eye on the coolant bottle level. Tighten sender back up and reattach the leads. Top off coolant bottle with 50/50 antifreeze/water mix. Remember! Do this with the engine COOLED DOWN!
How do you refill an engine coolant reservoir?
If using a premixed, ready to use engine coolant, skip this step. Open the plastic cap on the coolant reservoir. Place a funnel into the reservoir. Pour the properly mixed coolant into the coolant reservoir until the fluid level reaches the “FULL” mark. Place the reservoir cap back on and shut the hood of your vehicle.
Be sure to check your owners manual to determine the correct type of fluid to add – for Jeeps, it will typically be in a section titled Fluid Capacities in the back of your manual. Mix the coolant with distilled water so that you have a combination of 50% coolant and 50% water.