Where is the brake light switch on a 2004 Jeep Grand Cherokee?
The small component one inch below the brake pedal shaft-bar’s connection is the brake light switch.
How to replace the brake light on your car?
How to Replace a Brake Light Switch. Step 1 – Find the Brake Light Switch. The brake light switch is often found in the same location on all vehicles. You will need to open the driver Step 2 – Access the Brake Light Switch. Step 3 – Remove the Brake Light Switch. Step 4 – Replace the Brake Light …
Why does my brake light not turn on?
When the brake pedal is pressed, the switch signals the brake light to turn on. It is a fairly simple switch that is powered by a single electrical cable. The brake light switch can fail over time and, when that occurs, the brake lights will not switch on.
Where is the brake switch located on a car?
The switch is typically a small plastic box with 2 or 3 wires coming from it. It will make contact with the brake lever towards the top. Note: You may have to remove a plastic panel before you can access this area. Tip: You can sit on your knees or lay down on your back with your head right under the pedals.
Can a broken brake light switch cause a ticket?
You may also find yourself getting ticketed and having to pay fines. Always check the brake light bulbs first for damage because if they are broken it will mimic a bad switch. If the bulbs on the car are fine then the brake light switch is most likely to blame. Replacing the brake light switch is cheap and easy to do.
Where are the brake lights on a Jeep Cherokee?
There are usually three lights in the Jeep Cherokee rear taillight assembly and the top one is the brake light. Twist the back of the bulb counterclockwise to remove the bulb from the back of the assembly.
How do you change the brake light switch?
Rotate the switch in the clockwise direction to lock it in place. Note: While installing the switch you may have to press down on the brake pedal in order to insert it all the way. Step 3: Reconnect the battery. Now that the new switch is installed, reconnect the wiring harness and negative cable on the battery.
What to do if your brake light does not work?
Press down on the brake pedal and see if the lights illuminate. Note: On the newer style switch, you will not need to adjust anything and the lights should work after installation. If the lights do not work even after adjustment, a certified technician would be able to inspect the switch and diagnose the problem.
The switch is typically a small plastic box with 2 or 3 wires coming from it. It will make contact with the brake lever towards the top. Note: You may have to remove a plastic panel before you can access this area. Tip: You can sit on your knees or lay down on your back with your head right under the pedals.