Where is the airbag control module located?
In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min.
How do you reset passenger airbag sensor?
Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off. If it comes back on then the best thing to do is to take your car in for a diagnostics scan.
How do I reset my airbag light?
How to Reset an Airbag Light
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
What does the airbag warning light mean?
The airbag light is an indicator that there is a problem with the vehicle’s Supplemental Restraint System. This system includes various crash sensors and the airbags themselves.
How do I reset my service airbag?
Can a Subaru airbag be reset by myairbags?
The best part of having your Subaru’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
Where are airbag codes stored in a Subaru?
Below you will find common airbag codes that can be stored in your airbag control module after your vehicle was in an accident. The best part of having your Subaru’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play.
What happens to your airbag control module in an accident?
Send your airbag control module to MyAirbags and save time, money and not having to deal with a dealership! During an accident, seat belt retractors and tensioners are deployed and will lock up by their gas charges, similarly to how airbags are deployed in a collision.
Why do I need to reset my Honda airbag module?
Even after a minor accident the airbag may not deploy but the seat belts will lock and airbag module will need to be reset because of crash data and crash codes that are stored in the airbag module. MyAirbags will reset your airbag control module back to its original manufacturer state clear of all codes, both soft and hard codes.