Where is the ABS pump on a Kia?
Regardless of the Kia model, the ABS pump can be found in the engine bay. Unplug the connector. Press the red locking tab and release that first. Next, pull up on the grey connector to unplug the wire harness. Remove the brake fluid from the master cylinder using a syringe.
Are there any recalls on the Kia Sedona?
The affected vehicles, 2006–2010 Sedona minivans and 2007–2009 Sorento SUVs, are susceptible to engine fires when the car is off as the module remains energized. Kia recommends that owners park their vehicles outside and away from structures and other vehicles until the repair is done.
Where is the ESC Control Module on a Kia Optima?
Open the hood of your vehicle and disconnect the battery. Locate the ABS Module / ESC Control Module. This Kia Optima is located in the engine bay, passenger side near the firewall. Regardless of the Kia model, the ABS pump can be found in the engine bay.
How do you install a new ABS module?
Install the new ABS module in reverse order. Add brake fluid to the reservoir. The brake fluid level will go down as you start to bleed the air out of the system. Check the brake fluid level as you bleed the air and add fluid if needed. Remember to bleed air out of the system at each brake caliper. Start with the wheel farthest from the ABS module.
How do you remove the ABS module from a Kia?
Disconnect the brake lines from the ABS unit using an 11 mm wrench. The four brake lines that supply brake fluid to the brakes are held in place with small nuts. Remove the ABS module. Remove the bolts that hold the brake module in place.
Where is the ABS pump on a Kia Optima?
Open the hood of your vehicle and disconnect the battery. Locate the ABS Module / ESC Control Module. This Kia Optima is located in the engine bay, passenger side near the firewall. Regardless of the Kia model, the ABS pump can be found in the engine bay. Unplug the connector.
The affected vehicles, 2006–2010 Sedona minivans and 2007–2009 Sorento SUVs, are susceptible to engine fires when the car is off as the module remains energized. Kia recommends that owners park their vehicles outside and away from structures and other vehicles until the repair is done.
Install the new ABS module in reverse order. Add brake fluid to the reservoir. The brake fluid level will go down as you start to bleed the air out of the system. Check the brake fluid level as you bleed the air and add fluid if needed. Remember to bleed air out of the system at each brake caliper. Start with the wheel farthest from the ABS module.