Where is an actuator located?
The AC actuator is located above or below the coil. It can be set to either single speed or variable speed.
What do I need to replace car door actuator?
You will need a tool set including an 5.5 mm socket for Chevy, GMC, Cadillac, Ford and Lincoln vehicles. Using a small socket and ratchet remove the mounting bolts that hold the under dash plastic cover on the passenger side. These screws can be in obscure places so look around for them.
Can you remove a blend door actuator yourself?
If you are looking to cut some of your costs for the blend door actuator, then you can do so by doing the work yourself. This is a great way to save on labor costs, but you should only do that if it is a simple removal.
Where is the temperature actuator on a car?
Here is a typical right side temperature actuator used for dual climate controls (also temperature for signal mode units). This actuator hangs below the box which is one of the easier units to replace. Begin by using a small screwdriver to release the wiring safety clip on the harness for the actuator.
Can a heater be removed from a blend door?
If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit. To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level.
You will need a tool set including an 5.5 mm socket for Chevy, GMC, Cadillac, Ford and Lincoln vehicles. Using a small socket and ratchet remove the mounting bolts that hold the under dash plastic cover on the passenger side. These screws can be in obscure places so look around for them.
What happens when you replace the actuator on a blend door?
Once all of the mounting screws have been removed the actuator should become loose. Grasp the actuator and pull it from its mount to remove. Before installing the new actuator it’s a good idea to manually turn the blend door in both directions to ensure it is not stuck which will cause the new actuator to fail.
If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit. To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level.
Where are the actuators located on a car?
This direction is according to the temperature chosen by the driver or passenger on dual climate control systems. Most systems have three to four of these units placed in various areas around the HVAC plenum that control mode operation and will vary by the car make and model.