Where do you mount a satellite radio antenna?
Then you can run it along the floor trim or under the carpet to the back of your radio. Hatchbacks and SUVs make this a little easier. Mount the antenna on the back portion of the roof, then feed the cable through the hatch and underneath the weather seal.
How do you install a satellite radio in a car?
Look for a good location to enter the trunk. If necessary, notch the trunk’s edge with a round file to create an entry point. If you end up doing that, wrap the wire with some tape where it will contact the metal and replace the seal. You could add a dab of silicone where you filed down the metal if you wish.
How do you mount an antenna on a pickup truck?
Pickup trucks have a brake light above the cab’s rear window, which offers a convenient entry point. Simply remove the brake light and route the antenna wire through the opening. Feed it in through the bottom, and if necessary you can file a small notch in the plastic to allow for flush mounting of the brake light cover.
How do you mount an antenna on a brake light?
Simply remove the brake light and route the antenna wire through the opening. Feed it in through the bottom, and if necessary you can file a small notch in the plastic to allow for flush mounting of the brake light cover. A dab of silicone will keep water out at the entry point.
Where to mount a satellite radio antenna in a car?
First, get the antenna cable inside the car, and second, route it to the front under carpet or trim panels. With most sedans, it makes sense to mount the antenna on the roof in front of the rear window.
Where to mount a Sirius Satellite radio antenna?
Alexander Hrabe from Crutchfield. Posted on 10/17/2016 D, SiriusXM recommends that you mount the antenna outside your car for the best reception, but that might not work in your case. You may be okay with the antenna on your dash, close to the windshield. Give it a try in both positions and compare results.
How to mount a satellite dish on a pole?
Attach the clamp and side brackets using one (1) 5/16” x 3” hex screw with 5/16” hex nut and two (2) lag bolts for either wood or concrete as required (refer to Figure 13). Make sure the pole is level and plumb and then tighten everything down 8 Satellite Dish Installation Manual (Ver. 1) Section 6: Pole-Mounting the Mast Bracket
What is the installation manual for a satellite dish?
Satellite Dish Installation Manual (Ver. 1) Section 4: Satellite Dish Assembly Lay the dish flat to ensure it is not out of shape or damaged. Then attach the left and right reflector brackets and hand tighten them using four (4) ¼” x ½” round head bolts and ¼“ hex nuts.