Where do you fill the coolant tank on a motorcycle?
Fill coolant up to the point where the boom of the rad cap will be when fitted. After refitting the radiator cap, pour coolant into the header tank, filling it to the point halfway between the upper and lower fill marks. If there are bleed bolts present, use them to release any air, being sure to re-fix them tightly.
How do you change coolant in a Rad 6?
If there is any coolant left in the header tank, remove and drain, and clean out any residue before refitting. Now arm yourself with a funnel and coolant. If diluting antifreeze it should be done with distilled water or boiled kettle water – tap water contains minerals which will clog up the inside of the rad. 6.
Where do you put coolant in a radiator?
Purge any trapped air in the hoses by squeezing them gently. Fill coolant up to the point where the boom of the rad cap will be when fitted. After refitting the radiator cap, pour coolant into the header tank, filling it to the point halfway between the upper and lower fill marks.
How do you change coolant on a bike?
How to change your coolant: Place your bike upright on a paddock stand. On a sports bike you may need to take off most of the fairing in order to access the radiator cap, header tank cap and drain bolt.
How do you change coolant on a motorcycle?
Once the engine is flushed with the hose, pop the drain bolt back in using the old sealing washer, then half fill the system with tap water. After that, pour the bottle of flush into the radiator, then top up the system again.
How many litres of coolant do you need for a motorcycle?
Most bikes have a coolant capacity of three to four litres, although this can vary. Most coolants are pre-mixed and ready to add, but some coolants are sold as pure antifreeze; these must be diluted with distilled water – usually at a ratio of 50:50.
If there is any coolant left in the header tank, remove and drain, and clean out any residue before refitting. Now arm yourself with a funnel and coolant. If diluting antifreeze it should be done with distilled water or boiled kettle water – tap water contains minerals which will clog up the inside of the rad. 6.
Purge any trapped air in the hoses by squeezing them gently. Fill coolant up to the point where the boom of the rad cap will be when fitted. After refitting the radiator cap, pour coolant into the header tank, filling it to the point halfway between the upper and lower fill marks.