Where do I drain the oil before draining the engine?
If you have a car that comes with an insert oil filter which is typically located at the top of your engine, then it is advisable that you remove the oil filter first before draining the oil. This helps remove oil from the filter and channel it into the engine to be added into the oil to be drained afterwards.
How to install an engine oil cooler in a car?
1. Decide the Mounting Location For the best location of the cooler in the system, it is advised to install it, where it will receive the most of the cool air from the vehicle fan and motor. 2. Inspection of Filter
What should I do when I change the oil in my car?
Place the new oil filter. Every time you change your engine oil, it is already expected that you’re going to replace the oil filter as well. Also change the O-rings while you’re at it to help ensure a leak-free system. Lubricate the O-ring with the new engine oil you are going to fill your engine with. This helps ensure a perfect seal.
What should I do at the time of engine installation?
Drain & replace engine oils to manufacturers suggested levels. Replace oil filter. Timing belts/chains, water pump, thermostat, spark plugs, fluids, and seals are routine maintenance items and should be replaced at the time of installation and at the vehicle manufacturer’s recommended service intervals.
1. Decide the Mounting Location For the best location of the cooler in the system, it is advised to install it, where it will receive the most of the cool air from the vehicle fan and motor. 2. Inspection of Filter
What should I do when I install a used engine?
Proper operation of the cooling and electrical system must be checked during the installation of products that can be affected by those systems. Replace valve cover gasket as needed. Install new belts and hoses. These simple procedures will make sure the you get the most out of your used engine.
How do you install a piston in a motor?
Turn over the engine over to access the crankshaft. Use one end to rotate the crankshaft while the other guides the piston rod towards the crankshaft journals.
What should I do if I have an oil leak in my car?
Conduct a visual inspection for coolant or oil leaks around and under the engine. Adjust carburetor and ignition timing once engine is warmed to operation temperature. If the coolant should ‘boil over’ stop engine and allow to cool down for 30 minutes then start again, add water and proceed as above.