Where did my GMC Yukon XL transmission go bad?
My wife and four children (14,11,4,&3) stopped for lunch in a small town called FairPlay, CO. We loaded back up started back out on the road and lost of transmission function in forward and reverse. Turned our 2005 Yukon SLE off and waited for a few minutes and transmission started working again.
Where are the vent tubes on a GMC Yukon XL?
Installed a new GM trans and Engine into my 2002 XL Denali over the weekend and when hooking everything back up was confused about the vent line routing. There are 2 long vent tubes that go on the back of the transmission and it looks like one just ends to the open air.
What’s the transmission problem on a GMC Canyon?
They are concerned that this would start them down a slippery slope for repairing many 2015,16,17’s that have the same issue…Someone is going to get seriously injured or killed as a result of this transmission issue.” The gmc 2017 canyon vibrates at highway speed 60mph to 70mph.
Why is my traction control not working on my Yukon?
Traction Control Not Working – Your Yukon’s traction control system mostly uses the same sensors to determine if a wheel has broken traction. Unlike StabiliTrak, which controls lateral issues (sliding), traction control keeps the wheels from unnecessary spinning.
What does it mean when your Yukon won’t start?
This just means that the engine doesn’t move when you turn the key. The second way that your Yukon won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own. When the engine isn’t turning over at all, that’s a bit easier to diagnose than when it is cranking but not firing.
Why is my GMC Yukon not shifting into 3rd gear?
Driving at speed and the transmission suddenly started slipping while in OD – engine RPMs started racing, pulled to the side and dropped speed. 1st and 2nd gear are fine, but the tranny won’t shift into 3rd. Pulled off at the next exit, found a quick lube station, the tranny fluid (which had about 25 K miles on it) was scorched.
Why is my GMC Yukon stuck in 4WD?
Has gone into 4WD LO mode by itself. Can’t change drive mode. Problem and message will go away for weeks sometimes. When I start my 2005 GMC Yukon, it will often times, by stuck in 4WD and won’t switch to 2WD when I push the 2WD button.
How can I get my GMC Yukon XL back to 4WD?
Service 4WD notice routinely reported on dash. Inability to change 2WD to 4WD (or back) particularly after extended running period. Periodic solution by turning ignition off then back on, but solution is unpredictable. My Truck is stuck in 4WD Low.
Why does my GMC Yukon engine not start?
GMC Yukon: Engine Cranks → Won’t Start There are a lot of issues that can cause your Yukon to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
Who is the owner of the 2005 GMC Yukon?
2005 GMC Yukon/Yukon XL Owner ManualM GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Truck Emblem, and the name YUKON are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.
When did GMC Yukon SLT need to be replaced?
I got a 2002 yukon slt with a 4L60E tranny that had to be replaced around 85k miles. Im the 2nd owner and purchased when it had 67k miles. Previous owner stated they never used 4WD.