Where are the fuses in 2010 toyota sienna?
Fuse box location The fuse box is located under the instrument panel (on the left side), behind the lid.
How do you pull a Toyota fuse?
Locate the fuse removal tool within the fuse box. The fuse removal tool is a plastic set of tweezers held in place with a plastic clip. Pull the fuse removal tool off the plastic clip to remove it. Grasp the top of the “ALT-S” fuse with the fuse removal tool and pull directly up to remove it from the socket.
Where is the fuse box on a 2007 Toyota Sienna?
This fuse box is located behind the glove compartment.
Where is the fuse box on a 2004 Toyota Sienna?
The Sienna fuse boxes are located in the engine compartment on the right side looking in from the headlights and radiator.
How do you remove a fuse from a Toyota Sienna?
The engine bay fuse box is located at the right side of the engine bay next to the 12V automotive battery and the air filter box. Press in the release tab on the front edge of the cover and pull it off. There is a fuse location diagram on the underside of the cover.
How to fix a Toyota Sienna power door problem?
1. Disconnect the battery 2. Push and hold the door open button for 10 seconds (Dash or door buttons) 3. Now, this is key, open and close BOTH doors manually. 4. Wait 5 minutes then reconnect the battery. Not 3 minutes, not 4 minutes, but 5 minutes. This should do it. BTW, I have a door ECU if anyone wants it. $50.
Where is the power switch on a Toyota Sienna?
The 2nd Generation power switch is located to the left of the steering wheel, on the lower portion of the dashboard near the driver’s left knee. You can conceivably turn the power “off” and use the door manually all of the time, or as needed.
Where are the fuse panels on a Toyota Sienna?
Here you will find fuse box diagrams of Toyota Sienna 2004, 2005, 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Where is the ECU on a Toyota Sienna?
You can only move the motor so much after you remove its bolts because the cable it still attached at both ends. The ECU is barely visible. If you follow the wiring harness bundles you can find it behind the sheet metal. It is held on by 3 plastic clips and a bolt. Remove the bolt, but leave it in place until you unplug the 4 plugs that go to it.