When to replace the brake pads on a Jeep Cherokee?
If your Cherokee previously exhibited shuddering, pulsations, or vibrations in the rear end during braking, you may need to have your rotors “turned” (resurfaced) or just replace them with brand new rotors.
What kind of brake caliper does a Jeep Cherokee have?
The Cherokee is equipped with a “screw-in” type rear caliper piston. An optional item you may want to purchase for this procedure is a brake caliper piston tool. I found it relatively easy to wind back the rear caliper piston by using a pair of needle nose pliers.
Can you adjust the brakes on a jeep TJ?
The rear drum brakes on a Jeep TJ have been designed with a self-adjusting mechanism. Typically, no adjustments are needed to the brakes unless you have just replaced the drums, shoes or have removed the shoes for other reasons. Below are instructions on how to adjust your rear drum brakes using a brake spoon adjuster tool.
How do you remove a brake shoe from a Jeep Cherokee?
Reach behind your Jeep’s drum brake backing plate and press on the hold down spring pin. Then, using a brake spring compressor tool, push on the brake shoe hold down spring retainer and give it a twist to release it from the pin. Remove the shoe and repeat the process on the opposite shoe.
What kind of brake pads do Jeep Cherokees use?
Every off-road enthusiast knows that the ability to stop on a dime in harsh terrain is just as important as having the horsepower to drive on it. This is why aftermarket Jeep Cherokee brake pads from AutoZone are both popular and necessary. They’re specifically designed to handle what factory brake pads cannot. Loading Price
How do you change the brake bracket on a Jeep Cherokee?
Pull off the rear wheel to reveal the caliper, bracket, rotor and suspension. The rear brake caliper is held in place to the bracket by a nut on the top and a bolt on the bottom. Loosen the nut at the top of the caliper by turning it counterclockwise with a 10mm socket and a ratchet or a 10mm wrench.
How do you replace rear disc brake pads?
If your new set of rear pads includes replacement brake hardware, pull the old metal pad abutment or “anti-rattle” clips out of the top and bottom of the bracket. Apply a thin layer of brake caliper grease to the to new pad abutment clips where they will come in contact with the bracket or the new brake pads.
Where is the EPB on a Jeep Cherokee?
Push the lower pin back in to its rubber dust boot at the bottom of the bracket. Attention : If your Cherokee is equipped with an electronic parking brake or “EPB”, you must place it in “service” / “maintenance” mode by using the display screen on the dashboard as shown at the top of this page.
If your new set of rear pads includes replacement brake hardware, pull the old metal pad abutment or “anti-rattle” clips out of the top and bottom of the bracket. Apply a thin layer of brake caliper grease to the to new pad abutment clips where they will come in contact with the bracket or the new brake pads.
Push the lower pin back in to its rubber dust boot at the bottom of the bracket. Attention : If your Cherokee is equipped with an electronic parking brake or “EPB”, you must place it in “service” / “maintenance” mode by using the display screen on the dashboard as shown at the top of this page.