When is a 3712 and 3714 fault code are triggered and an?
Have Codes 3712 and 3714, they will not clear and truck is stuck in derate. … read more Vocational, Technical or Tra… Got 4 active fault codes in Cummins ISB6.7. AutoCAD ACX Vocational, Technical or Tra… Yellow Def light is blinking. Replaced header due to tank Yellow Def light is blinking.
What are the DTC codes for a Freightliner?
DTC’s 3868, 4677, 4572, 3714, 3712, all these codes a related to the deg level guage assembly. Check harness, and voltage to gauge should have 12V, 2.4V, 2.5V, and a ground. If voltage are ok, then try changing the gauge assemble. If voltage are no good, trace harness back to ECU. Loading…
What are the fault codes for Freightliner M2?
Freightliner Business Class M2 Fault Codes List -… * On March 7, 1997. If there is no text message, the display area will be blank. Only the MID number will display. * On March 7, 1997. * On March 7, 1997. * On March 7, 1997. 154 Auxiliary IN / OUT Status # 2 AUX INP / OUTP # 2 Aux. In / Out # 2
What does the code 3712 on the ECM mean?
This fault code is for information only, and indicates that an engine power derate and vehicle speed limit have been implemented in order to make sure that the critical SCR related fault codes that are presently active in the ECM are addressed as quickly as possible. Refer to Troubleshooting Fault Code 3712.
What’s the fault code for a Cummins derate?
It sets fault code 3714 – Engine Protection Torque Derate – Condition Exists. The driver display says 25% torque derate in 3 hours. It starts to count down, but never goes 3 hours until it clears itself.
Is there a torque derate condition on a 2013 Cummins?
I have had a 2013 Pete with an ISX15 CM2350 550HP in the shop several times over the past month that is driving me nuts. It sets fault code 3714 – Engine Protection Torque Derate – Condition Exists. The driver display says 25% torque derate in 3 hours. It starts to count down, but never goes 3 hours until it clears itself.
How long does it take a Cummins engine to derate?
It sets fault code 3714 – Engine Protection Torque Derate – Condition Exists. The driver display says 25% torque derate in 3 hours. It starts to count down, but never goes 3 hours until it clears itself. It has not actually derated.
What does code 3714 mean on a Cummins car?
Cummins®fault code 3714 present with no other codes active. Note that the information covered in this TSB is also contained in Cummins®Technical Service Bulletin TSB110187. Issue During an active regeneration, the aftertreatment fuel injector injects fuel into the exhaust stream to raise the temperature of the exhaust.
What is the aftertreatment fuel injector code 3714?
Cummins®fault code 3714 present with no other codes active. Note that the information covered in this TSB is also contained in Cummins®Technical Service Bulletin TSB110187. Issue During an active regeneration, the aftertreatment fuel injector injects fuel into the exhaust stream to raise the temperature of the exhaust.
What does code 3714 mean on Westport HD?
When Fault Code 3714 is active, as described here, the torque derate associated with the fault will also be active. Drivers may complain of power and/or torque loss. Applicability This TSB applies only to manual transmission EPA10 model Westport HD system-equipped vehicles displaying Cummins®fault code 3714 and no other active codes. Resolution