When do you turn off the oxygen sensors on a Jaguar?
Upstream (Universal) oxygen sensors: Engine OFF; cooling fans inoperative > 20 seconds. Start engine and bring to normal operating temperature > 82 °C (180 °F). Drive the vehicle between 3000 – 4000 rpm at a steady speed. Lift foot completely off accelerator and coast to a stop within 30 seconds.
What should the engine temperature be in a Jaguar OBD-2?
Oxygen sensor heaters: Start engine and bring to normal operating temperature > 82 °C (180 °F). Idle engine for 3 minutes. Start engine and bring to normal operating temperature > 82 °C (180 °F). Idle for a minimum of 10 minutes.
What are the OBD procedures for a Jaguar?
Welcome to the Jaguar onboard diagnostics OBD-II drive cycle information page. The procedures detailed below apply to many but not all 1996-newer Jaguar models. The steps should generally be the same but refer to an authorized Jaguar repair/service guide or possibly owners manual to confirm steps for your Jag.
What kind of Diagnostic monitor does a jaguar have?
The diagnostic monitors for your Jaguar may include: Heated Oxygen Sensors Monitor Adaptive Fuel Monitor Misfire Monitor Catalyst Efficiency Monitor Evaporative System Monitor Exhaust Gas Recirculation Monitor Drive Cycle Comprehensive Component Monitor (Engine Management / Transmission)
Upstream (Universal) oxygen sensors: Engine OFF; cooling fans inoperative > 20 seconds. Start engine and bring to normal operating temperature > 82 °C (180 °F). Drive the vehicle between 3000 – 4000 rpm at a steady speed. Lift foot completely off accelerator and coast to a stop within 30 seconds.
What is the diagnostic code for a Jaguar check engine light?
Refer to our Generic OBD II code list for definitions on all other Jaguar diagnostic trouble codes. Manufacturer Specific Codes P1000OBD Systems Readiness Test Not Complete P1104Mass Air Flow Sensor Circuit Ground – Read Our Article On Automotive Circuit TestingFor Help With This Jaguar Check Engine Light Code P1111System Pass
Oxygen sensor heaters: Start engine and bring to normal operating temperature > 82 °C (180 °F). Idle engine for 3 minutes. Start engine and bring to normal operating temperature > 82 °C (180 °F). Idle for a minimum of 10 minutes.
How to do an OBD drive cycle on a Jaguar?
Heated Oxygen Sensors Monitor Drive Cycle. Start engine and bring to normal operating temperature > 82 °C (180 °F). Drive the vehicle steadily between 48 – 97 km/h (30 – 60 mph) for 10 minutes. Drive the vehicle above 3000 rpm in 4th gear at a steady speed. Lift foot completely off accelerator and coast for 30 seconds.