When do you need to replace brake pads on an Audi A3?
The brake system in your Audi A3 is considered to be one of the most hard working systems on your vehicle. The brake pads sacrifice themselves for your safety, as it rubs on the brake rotors to stop the car. The pads and the rotors both need replacement, as they wear when you step on the brake pedal.
How to replace parking brake and handbrake in Audi?
There is a vid on YouTube, where the guy releases the electric parking brake and then removes the actuator from the assembly then he removes the pads and uses a hex to wind the calliper back in and fits new pads then replaces the unit. He then puts the handbrake on and off a few times to recalibrate the unit, job done. Click to expand…
What to do when rear brake pads need to be replaced?
You should hear the rear caliper motors operating. Turn ignition off and leave battery charger connected. The caliper pistons do not move back into the caliper, they must be pushed in using a hand tool. Fault code 721152 – Brake pad replacement mode active will be stored, this is normal.
Where are the brake jacks on an Audi A3?
First things first, break the lug nuts loose on all four wheels. Take a look underneath the A3 and locate the jacking points—they are clearly marked. Raise the car, support on stands and then remove the wheels to gain access to the car’s braking system. Figure 1. Side jack point for Audi.
How do you replace brake pads on an Audi A3?
Lift up the brake caliper, and the brake pads will stay on the rotor in their bracket. Place the caliper somewhere safe, where it doesn’t hang from the brake line. The pads have clips on the back, so just pull them off. Install the inside new pad onto the brake caliper, where the clip goes inside the caliper’s piston.
Why are my brake pads not working on my Audi?
This is because the wagon and SUV models have more rear brake bias adjustment due to the extra weight. Most models manufactured before 2010, didn’t include wear sensors on the rear Audi brake pads, thus won’t cause the brake pad warning light to come on.
How big are the brakes on an Audi A3?
The RS3 brake upgrade consists of calipers, pads and rotors. Due to the increased size of these brakes, 18″ wheels at a minimum will be required to fit them. These brakes are specially designed for the more aggressive driver.
Where are the sensors on the brake pads on an Audi?
Depending on your model, most front Audi brake pads have wear sensors that are either built right into the brake pad material or are separate. These sensors may be on one side of the vehicle or both. If you see the Audi brake warning light illuminated on your dash board instrument cluster, brake repair service is imminent.