When did power sliding door on Toyota Sienna Le stop working?
In 2014, the driver’s side power sliding door cable snapped on our 2009 Toyota Sienna LE with about 150,000km. It stopped working and you could see a rusted cable hanging outside of the third row window.
How do you replace a sliding door cable on a Toyota Sienna?
Without further ado, here’s how you can replace the side door cable assembly in your Sienna: Take out the seat closest to the defective sliding door. (Optional; this just gives you more room to work on the door.) Roll down the window on the defective door. On the side of the door is a hex screw holding the plastic panel in place.
How to open driver side manual sliding door?
How to open Toyota Sienna Driver side Manual sliding door if stuck. – YouTube How to open Toyota Sienna Driver side Manual sliding door if stuck. If playback doesn’t begin shortly, try restarting your device.
Where is the release actuator on a Sienna?
There’s a pulley system with a Sienna side door release actuator in the bottom corner of the door. (If you’re working on the right door, the pulley system is in the bottom right corner; on the left door, the pulley system is on the bottom left corner.) Remove all of the screws holding it in place. Slide-out the side door cable assembly.
What to do when your side door won’t open?
The only way you can get the door open is to pull the handle and then hold it for two or three seconds. This happens when the latch motor fails, which is fairly common in Toyota Siennas.
What does CSP stand for in Toyota Sienna?
It is a Customer Support Program (CSP) extended warranty meant to enhance Sienna ownership experience and satisfaction. It covers the power sliding door latch assembly and/or the power sliding door cable assembly on certain model Sienna’s.
How much does a 2001 Sienna Le cost?
My 2001 Sienna LE right side power door quit working and was going to cost about $1200 for a new drive motor and ECU. I decided to remove the drive motor and cable to convert it to a manual door. It slides just as easy as the manual left side door now. It wasn’t too difficult to do.
Where is the power switch on a Toyota Sienna?
The 2nd Generation power switch is located to the left of the steering wheel, on the lower portion of the dashboard near the driver’s left knee. You can conceivably turn the power “off” and use the door manually all of the time, or as needed.
Where is the button on the side of the sliding door?
Note: At some point you will either want to disconnect the positive battery terminal from your battery or simply put the sliding doors in manual mode so you can manually open and close your sliding door as needed to complete the repair. The button to put the sliding doors in manual mode is located at the left knee of the driver:
What’s the name of the sliding door on a Sienna?
(Playback ID: zpBDlbdDS0SWKmL6) An error occurred while retrieving sharing information. Please try again later.
Is the driver side slider on a Toyota Sienna?
Hi, I’m new to the forum and a relatively new used Sienna owner. I have an ’08 Limited that I got off the used car lot. I replaced the battery after getting it home and lost function of the driver side slider.
How to replace power sliding door cables on 2004-2010?
[I] have a 2004 XLE… driver side cable-spool finally jammed/broke as they all do. At that time, followed your instructions, but bought the cable only repair part for around $200. I wound the spool successfully, and it’s not that hard to.
Why did my power sliding door cable snap?
The plastic cable coating failed, and ultimately cross tangled on the spool leading to the cable snapping. No warning, just “bang”, dead. I believe the root cause is one of two things or both: 1) The replacement cable was of insufficient quality, 2) and/or the spool was compressed or compromised during the initial failure.
Why does my Sienna Le not open or close?
So out of the blue, our 06 Sienna LE’s passenger side power door stopped opening/closing using either of the interior buttons. It pops and tries to open/close, but it acts like it’s totally stuck. BUT, when using the handles, both interior and exterior handles, the door powers open/closed flawlessly.
Why does my Toyota power door not open?
It pops and tries to open/close, but it acts like it’s totally stuck. BUT, when using the handles, both interior and exterior handles, the door powers open/closed flawlessly. Seems to only have the problem when using the switches. Anyone else run into this? Thanks! Interesting.
Where are the actuators on a Toyota Sienna?
A Sienna with dual zones will have 2 actuators, driver side & passenger side. Our problem was the driver’s side. It can be accessed from the floor of the driver’s side, behind the center of the dash near the floor. Basically to the right of the accelerator pedal. A search here will reveal more detail on how to remove it, but it’s relatively simple.
Where are the dual zones on a Sienna?
A Sienna with dual zones will have 2 actuators, driver side & passenger side. Our problem was the driver’s side. It can be accessed from the floor of the driver’s side, behind the center of the dash near the floor. Basically to the right of the accelerator pedal.
Why does my Toyota Sienna have no power?
You’ve got a main connection problem. Check that the negative connection from the battery is properly attached to the car body, with no corrosion. The positive connection leaves the battery and goes to a small terminal block. I once had this come loose and the van died on the road.
What’s the problem with my 2005 Toyota Sienna?
I am having a puzzling problem with my 2005 Toyota Sienna. Yesterday, shortly after returning from a short trip, I tried to start my Sienna without success. When I turned the key to start the car, I got nothing–no clicking, no cranking, no idiot lights on the dash–nothing.
Why is there no oil in my Toyota Sienna?
As a result, oil leaks out of the hose and, if not caught in time, the engine will have no oil left and may seize. Many Sienna owners successfully resolve this issue by replacing it with an OEM metal cooler pipe (Part No. 15767-31020 ).
How to reset the power door battery on a Toyota Sienna?
Step 1 Press the sliding door control button on the Sienna’s dashboard so that the red line on the button is illuminated. Close the sliding doors. Raise the hood of the van, and disconnect the negative (“-“) battery cable with a wrench. Wait 3 to 5 minutes, then reconnect the cable.
How do you open the doors on a Toyota Sienna?
Simply use a quick kicking motion with your foot to open and close Sienna’s available kick-activated 87 dual power sliding doors and rear liftgate 100 to make getting in and out easier.
What kind of warranty does Toyota Sienna have?
1) Rear Sliding Door Latch Assemblies – For certain 2004-2010MY Sienna vehicles equipped with a Manual or Power Sliding Door, the warranty coverage for the Rear Sliding Door Latch Assemblies will be extended to 9 years from the date-of-first-use or 120,000 miles (whichever occurs first).
Where can I buy a genuine Toyota sliding door motor?
In Stock. Ships from and sold by Conicelli Toyota of Conshohocken- Partznet. What other items do customers buy after viewing this item? Amazon Business : For business-only pricing, quantity discounts and FREE Shipping. Register a free business account Would you like to tell us about a lower price? Video Player is loading. This is a modal window.