What was the problem with the 2005 Jeep Wrangler?
Chrysler changed the oil pump drive assembly (opda) on 2005-06 model Jeep Wrangler. The opda was designed with a seal preventing oil from lubricating the upper bushing causing premature failures. These failures will result in a immediate drop in oil pressure causing the potential for complete engine failure at highway speeds.
What kind of brake pads does a Jeep Wrangler TJ have?
1990-2001 Jeep Cherokee XJ; For 4423601 Wheel Cylinder. Set of 2 (Left & Right); Rear; High performance cross drilled and slotted rotors. 2003-2006 Jeep Wrangler TJ; without pads; Left.
When did the Jeep Wrangler Rubicon Sahara come out?
I purchased my Jeep Wrangler rubicon sahara in July 2005. Over the years, the biggest problems I had were the infamous shaking of the car at speeds over about 55mph and the constant need to jump the car and buy new batteries.
Are there electrical issues with my Jeep Wrangler?
Have had ongoing electrical issues beginning in August, 2010. Check engine lights that have been proven inaccurate. Have replaced fan motor resistor X 2, electrical control unit X1, fan blower X1. Wiring is melted (burnt) at locations indicating fuse system/ wiring harness is not functioning properly.
What are the engine codes on a 2005 Jeep Wrangler?
Engine codes P0340 and P0344 Chrysler campaign E05 replace opda and camshaft – my manufacture date is June 2005, there is 113K on the engine, when the weather is cold (40 F or below) the engine has long start issues, there is play in the opda enough to put the engine in limp mode not revving past 2500rpm.
What was the problem with my 2005 Jeep Wrangler?
The contact owns a 2005 Jeep Wrangler. While driving, the rpms would not increase past 3,000 rpms. The vehicle was taken to the dealer where it was diagnosed that the oil pump drive needed to be replaced. The vehicle was repaired, but the failure persisted. The manufacturer was notified of the failure.
What’s the mileage on a 2005 Jeep Wrangler?
The contact owns a 2005 Jeep Wrangler. While driving, the rpms would not increase past 3,000 rpms. The vehicle was taken to the dealer where it was diagnosed that the oil pump drive needed to be replaced. The vehicle was repaired, but the failure persisted. The manufacturer was notified of the failure. The failure mileage was 57,201.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.