What tool do you use to remove U joints?
The OTC U-Joint Removing / Installing Tool is extremely useful in assembling and disassembling U-joints. The basic C-frame press is used to service the U joints on most cars and light trucks, either on or off the vehicles.
Where are the U-joints located?
rear drive shaft
U-joints are found on each of the ends of the rear drive shaft, whereas CV-joints are found on front wheel drive cars. Each allows the drive shaft to rotate as the differential moves in relation to the rest of drive train mounted on the chassis.
What happens if u-joint breaks while driving?
A bad u-joint can cause a clunking sound or jerkiness while driving, particularly when letting off of and pressing the accelerator. A bad u-joint can also cause vibration at certain speeds, emanating from the center or rear of the vehicle. Then, shift into drive.
Is there a special tool for U joints?
U-Joint Snap Ring Pliers – The unique jaw is specifically designed to easily remove and replace Hotchkiss style snap rings on universal joints.
Where are the clips on AU joint?
There are two styles of clips that retain the caps on a u joint. The clips on the out side of the cap are typical of drive shaft u joints. The “C” Clips that fit behind the cap is typical of an axle shaft. Breakdowns and broken parts are about as common as dirt in your face and wind in your hair.
Where can I get a replacement U-joint for my Chevy S-10?
Replacement U-joints are available from any auto parts store or through your local Chevy dealer. Raise the rear of your S-10 with a jack then position a set of jack stands under the rear axle to support the truck. Lower the jack until the truck is resting on the stands securely.
How do you remove a you joint from a hard drive?
Turn the screw on the U-joint press with a socket and ratchet to force the U-joint out of the driveshaft. Remove the press and position it on the next U-joint cap, repeating the process until all four caps have been pressed out. Remove the joint from the driveshaft and discard it.
What are the U-joints on a pickup truck?
The U-joints connect the driveshaft to the transmission and differential, allowing the driveshaft to spin while traveling up and down with the suspension. If the U-joints become worn, they may fail, damaging the driveshaft, differential or transmission in your S-10 pickup.
How do you raise the rear of a S-10 truck?
Raise the rear of your S-10 with a jack then position a set of jack stands under the rear axle to support the truck. Lower the jack until the truck is resting on the stands securely. Locate the four retaining bolts where the driveshaft meets the rear differential then remove them with a wrench.