What to do if your GMC Sierra 1500 wont start?
If you discover white deposits or silvery-green deposits, but no further cracks or damage, you do not have to replace the battery, just clean it. To clean the battery on your GMC Sierra 1500, you have to remove the pole cables first, which requires no special knowledge, just a little concentration, as the order is very important.
What kind of engine was in a 1997 Chevy Tahoe?
The 5700 engine appeared in the 1997 Chevrolet Express, Chevrolet Suburban, Chevrolet Tahoe, Chevrolet/GMC full-size trucks and the Cadillac Escalade. This engine was replaced in 2002 by the 5.3 5300. The premier Vortex engine during 1997 was the 4300 or 4.3 L V-6 90-degree engine that replaced the Chevrolet 250 in all light truck applications.
What kind of engine did Chevy have in 1997?
Chevy placed a vortex or mini tornado within the combustion chamber to efficiently blend gas and air together. Vortec engines are the base engine used in all Chevy cars and trucks and come in a variety of horsepower and torque ratings. During 1997 Chevy still had a big block engine, the 454 cubic inch.
Can a Chevy Silverado 1500 start and run?
Although I tried to start it multiple times over a couple weeks I gave it one last try after I called the tow truck. It started right up and engine stayed running like it was supposed to. No more problems for almost a year until about a week ago. I did nothin to fix it a year ago.
Why does my GMC Sierra suddenly stop running?
Truck suddenly stops running, acting like it’s out of fuel. There is fuel in the gas tank and, I can hear the fuel pump when I turn the ignition on. Is there a fuse, or relay that is maybe causing this to happen?
The 5700 engine appeared in the 1997 Chevrolet Express, Chevrolet Suburban, Chevrolet Tahoe, Chevrolet/GMC full-size trucks and the Cadillac Escalade. This engine was replaced in 2002 by the 5.3 5300. The premier Vortex engine during 1997 was the 4300 or 4.3 L V-6 90-degree engine that replaced the Chevrolet 250 in all light truck applications.
What to do if your GMC Yukon won’t start?
No matter what I do… take the battery cable off, pull and replace fuses… etc, it just will not start However, if you wait exactly 15 minutes, it will start perfectly fine. Somebody suggested to me that the security system was kicking in and shutting off the ignition coil until it automatically cleared after 15 minutes.
If you can’t run a hose to a pail get a small bucket or container and get someone to start and run the truck briefly with the fitting cracked but not disconnected. You should see fluid coming out. If you don’t the lines, cooler, pump or pick-up from the tranny pan may be plugged or frozen.
When to crack return line on GMC Sierra 1500?
Crack the return line at the tranny or after the last cooler (I do the one on the tranny because I can disconnect the line completely and slip a hose on the end to limit the mess and I have access to a heated shop).
Can you feel the gears on a GMC Sierra?
When you move the shifter can you feel the regular amount of resistance, can you feel the gears. If not the cable is broken or disconnected from the tranny. 94 people found this helpful. If the cable is good we need to check line flow/pressure.
Why did my Chevy Silverado 1500 go off while driving?
I drove it for about 15 minutes. The battery gauge showed 14 volts while driving, so the alternator was good. The headlights went off when I turned the key to the on position with the truck in park. Yesterday they had stayed on.
If you can’t run a hose to a pail get a small bucket or container and get someone to start and run the truck briefly with the fitting cracked but not disconnected. You should see fluid coming out. If you don’t the lines, cooler, pump or pick-up from the tranny pan may be plugged or frozen.
Is there a way to reset a GMC fault code?
GMC specializes in sport utility vehicles, trucks and vans. If your GMC vehicle sets off a fault code, also known as a check-engine code, resetting the code after the repair has been made is a simple process. Once you locate the battery, the method for clearing the code is the same, regardless of the year, make or model of GMC vehicle.
When you move the shifter can you feel the regular amount of resistance, can you feel the gears. If not the cable is broken or disconnected from the tranny. 94 people found this helpful. If the cable is good we need to check line flow/pressure.
Crack the return line at the tranny or after the last cooler (I do the one on the tranny because I can disconnect the line completely and slip a hose on the end to limit the mess and I have access to a heated shop).
How do you reset the computer on a GMC?
This scan tool can be purchased from most auto parts stores and is required to reset the vehicle’s computer. Open the door on your GMC vehicle and locate the port to the left of the fuse panel. Plug the electrical connector from the OBD scan tool into the OBD port. Turn the ignition key to the “II” position.
What to do if your GMC Truck wont start?
No relearn is necessary. In this situation, the vehicle will start and run with no problem. If the vehicle won’t start, check your scan tool for a VTD (Vehicle Theft Deterrent) Fail-Enable Mode trouble code, or if the security light on the dash is illuminated.
Where does the GMC Sierra 1500 AT4 go?
This quadrennial event challenges teams to drive through Canada, Alaska and into the Arctic Circle. With temperatures well below freezing, see how these three used their Sierra 1500 AT4 to witness beautiful backdrops and experience some of the most isolated regions of North America.
Which is the latest generation GMC Sierra truck?
GMC has always made top-level engineering the rule, and the latest-generation Sierra is no exception. Watch the video to see the best of what Sierra has to offer in action. 1.
Is there a problem with the ignition on my GMC Sierra?
This problem occurs in minivans, cars and SUVs as well. There has been more reports of ignition Anti Theft defects and the security light flashing in more cars and trucks. This is one of the easy fixes for the common ignition starting problem, but GM needs to recall this issue and fix it for us.
Why is my GMC Sierra k1500 not shifting?
I have a 95’ k1500 it’s got a 4L60E but apparently it just needed a new oil pump which I replaced but I put it in about 2 months ago but it isn’t shifting out of 1st and the reverse isn’t working well it’s working but it takes a little longer for it to cooperate. Could it be the torque converter or a the solenoids?
Why is my GMC Sierra not four wheel drive?
I have a 2004 GMC Sierra Truck. The transfer case will not engage into four wheel drive. I took it to a GMC dealer and they are saying that is internal, but can not diagnois it until it is taken apart. Anyone have any suggestions?
Why does my GMC Sierra 1500 not work?
While there are a variety of reasons your GMC Sierra 1500 air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor. What will be the outcome of an air conditioning system diagnosis?
When do you Know Your GMC Sierra ignition switch is bad?
If your GMC Sierra is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad. Here’s what happens. You aren’t getting power to the ignition or fuel pump while the key “rests” in the run position.
Why is my GMC Sierra 1500 in 3rd gear?
Pulled the harness off the tranny to put it into LIMP mode and it starts out in 3rd gear no problem. So 3rd gear is there.. Shift solenoids A and B have to be good else no 1st or 2nd. No errors codes.
What should I do if my GMC power window is not working?
If there is power, then check the dark blue wires at pin B of the window switch for voltage. If no voltage is detected on any or some of the wires, the wiring in the door jamb should be wiggled while the voltage is monitored to see if the is a fluctuation. If there is, it indicates broken or loose connections in the door jamb.
How does the starter work on a GMC Sierra?
The starter in your GMC Sierra is dependent on three pieces of equipment. First, the ignition switch sends electrical current from the battery to the starter solenoid. The solenoid then forces the gear in the starter housing to engage the engine. When the starter motor turns on and spins the gear, the engine roars to life.
Can a truck start but won’t go into gear?
Truck starts but you put it in gear and it won’t move! Won’t go into gear. No I haven’t where is the brake switch put it in neutral and reverse. It was in the way so I used another truck to push it out of the way. The back wheel drug like something was holding it … read more I have a 2008 Chevy Silverado 1500. The issue is the truck
Why does my Silverado 1500 not go into gear?
Won’t go into gear. No I haven’t where is the brake switch put it in neutral and reverse. It was in the way so I used another truck to push it out of the way. The back wheel drug like something was holding it … read more I have a 2008 Chevy Silverado 1500. The issue is the truck I have a 2008 Chevy Silverado 1500.
Why does my GMC Sierra k1500 not move?
1995 GMC Sierra k1500, 350, 5.7 Automatic : Take it out of park, into drive or reverse, step on gas, rpm’s fly, but won’t move an inch. Have not driven in a week or so, had to replace radiator because of leak, replaced radiator yesterday and it works fine.but now get no movement at all when out of park.
What to do if your GMC Sierra won’t start?
Let sit for awhile, turn key, won’t start, turn key off, turn key again, starts up and runs great. A week later, same issue. I went to work everything great, went to go home, wouldn’t start. Tried to turn key a few times, won’t start, let sit about 15 min., turned key, started up. Stop to get gas 15 min. later, wouldn’t start. Stranded for 2 hours.
How do you shift a GMC Sierra 1500?
You would have to push the 2HI and 4LOW buttons at the same time, and hold them there til the red NEUTRAL light came on, if it’s electronic shift. 19 people found this helpful. You might try to shift the transfer case, after warming up the vehicle for a good amount of time.
What causes a Chevy truck to not move?
So transmission is working properly and shifts through gears and goes in reverse, all with Tranfer Case in 4WD Auto. With transfer case in 2WD the truck will not engage and will not move, and with 2 failures in 2WD there is clearly something wrong.
Can a 2001 GMC Sierra 1500 be tested?
The 2001 GMC Sierra 1500 has not been tested. Like what you see? Find the best deal on a GMC Sierra 1500 today. There are for sale near you. Certified child passenger safety technicians conduct hands-on tests of a car’s Latch system and check the vehicle’s ability to accommodate different types of car seats.
What are the fuses on a GMC Sierra?
RH Turn and Stop Lamp) ECM 1 Fuse #15 10A Vehicle Control Module (VCM)/Powertrain Control Module (PCM) from IGN I Relay) INJA Fuse @20 15A Fuel injectors 1. 3, 5, and 7. Ignition Coils. Glow Pug Module, Fuel Heat. Water in Fuel (WIF) Sensor, Wastegate Solenoid IGN E Fuse #25 10A NC Compressor Clutch Relay.
What kind of engine does a GMC Sierra have?
Thanks For Signing Up! GMC tries to add more pizazz to its light-duty Sierra lineup with the C3, an extended cab with a 325-horsepower 6.0-liter V-8 engine, permanently engaged four-wheel drive, a monotone exterior and unique front styling.
Is there a remote starter for a GMC Sierra?
Start-X Remote Starter for Silverado & Sierra 1500/2500/3500 2015-2021 || Plug N Play || 3 X Lock to Remote Start || 5 Minute Install || USB Updater Included || Zero Wire Splicing! . . . . .
When did the GMC Sierra truck come out?
The GMC Sierra is the fifth-most popular truck in the United States, with more than 230,000 trucks sold in 2019. General Motors introduced the GMC Sierra and its twin, the Chevrolet Silverado, in 1998.
What are the specs of a GMC Sierra 1500?
Driver & front passenger airbags w/passenger side deactivation… Manual lap/shoulder safety belts, front/rear outboard seat… Looking for other models of the GMC Sierra 1500?
When did the GMC Sierra have the most problems?
The model years with the most problems reported were 2004 and 2007, with more than 60 complaints each year, followed by 2002, 2003, 2005, and 2010, with more than 40 each year. Of the 112 problems, five different complaints have been reported 90 or more times.