What to do after Idle Relearn on Chevy?
Blue Streak Electronics recommends to warm the engine after the idle relearn procedure, without use of the air conditioner. After the engine is warm, switch the air conditioning on and off, and then put the transmission into the “drive” position. These actions complete the full idle relearn procedure.
Is there a manual relearn procedure for a Silverado?
Stalling…
8L regular cab chevy Colorado … read more 2010 Avalanche 5.3, check engine light came on, stabilitrak issue, low engine power. Replaced throttle body. Is there a manual relearn procedure? … read more my 2008 Silverado is idling high after cleaning the throttle body so I changed the tps and now it idles high .
When do you need an idle relearn procedure?
An idle relearn procedure must be performed if a computer, or chip, is replaced in the vehicle. An idle relearn procedure is a way to reprogram the vehicle’s computer memory to idle at a specified RPM, or revolutions per minute.
How to relearn a procedure on a GMC after changing?
Without resyncing, the PCM cannot properly determine the position of the crankshaft. The proper procedure for resyncing or relearning the crankshaft position is called the “CKP Variation Learn.”
What’s the average idle speed of a GM Sierra?
I did the relearn procedure from the gm tech section, I did relearn procedure #4, then drove at speeds up to 50 mph for 5 minutes, according to the sheet it only had to be over 44 mph. Starts up idles fine, as soon as you put in gear it takes off on its on, and will run up to about 30-35 mph without ever touching the gas pedal.
What should I do if my Silverado Idles high?
Replaced Throttle body On 2008 Silverado And It Idles High. Help! Replaced Throttle body On 2008 Silverado And It Idles High. Help! I cleaned my throttle body and replaced throttle body position sensor on my 2013 Chevy Silverado 5.3L.
Stalling…
8L regular cab chevy Colorado … read more 2010 Avalanche 5.3, check engine light came on, stabilitrak issue, low engine power. Replaced throttle body. Is there a manual relearn procedure? … read more my 2008 Silverado is idling high after cleaning the throttle body so I changed the tps and now it idles high .
Without resyncing, the PCM cannot properly determine the position of the crankshaft. The proper procedure for resyncing or relearning the crankshaft position is called the “CKP Variation Learn.”