What to do about rear axle nut torque on Harley Davidson?
The best way to get around this is by removing the rear muffler and then use a ratcheting tie down strap to compress the motorcycle’s rear suspension. This will pull the frame and exhaust bracket down & out of your way.
How can I check the torque on my rear axle?
To check the nut torque, use a 36 millimeter socket and set the torque wrench to 95 to 105 foot pounds. You do not need to remove the axle retaining clip. If you do not have access to the correct torque wrench, you should at least take the time to make sure that the axle nut is not loose. Check this component at every service interval.
How big is the torque wrench on a Harley Davidson?
Here is what i propose to do with both the transmission and the engine oil plugs , since the range for both is 14-21 ft. Lbs. Since my torque wrench is a clicker type 1/2″ drive , i will set it at 18 ft.lbs. .
What’s the torque setting on a Harley Davidson?
Actually, I a bit the opposite of Hoop and closer to B-1B…using the lower torque setting based on fact all fasteners on the bike are “used” and generally installed “wet” with Locktite liquid/sealer at the time of installation. I am also on the old school, that checks the critical fastener list for good measure as to how things are going.
What should the torque be on a Harley Davidson?
Set the correct belt deflection for your year and model. Then correctly torque the axle nut to 105 ft lbs.
What should my rear axle nut be set to?
Lets say my rear axle nut needed to be set to 90-105 ft/lbs. What value would you shoot for. If I understand you correctly, your saying you would tighten it to 95% of 105?
When did the torque specs come out for the Softail?
Discussion in ‘ Softail Models ‘ started by BOWHIKER, Mar 17, 2010 . I printed off the complete torque specs for the softail models .
What kind of fasteners does a Harley Davidson use?
This table is based upon Grade 5 fasteners, generally used Harley-Davidson motorcycles.