What size are Jeep Patriot headlights?
For the 2017 model year, the Jeep Patriot utilized the H13 bulb for both the high beam and low beam headlights.
How to replace a headlight bulb on a Jeep Patriot?
The New Bulb. There are two sides on the headlight bulb. One has writing on it, the other has the latch to attach it to the plug. You want to have the red locking mechanism facing up on the plug and the latch side of the bulb facing up when you connect them together.
When did the 2007 Patriot headlamp bulb fail?
Passenger headlamp for my 2007 Patriot just failed at 136,000km. New H13 bulb didn’t fix. 3 wires to the bulb, the middle is the ground. Measured the voltage on the bad passenger side and it was lower than that of the working driver side.
Where is the ground eyelet on a Jeep Patriot?
On the passenger side, there’s a ground eyelet secured to the frame near the bottom of the antifreeze reservoir. Take the bolt off, remove the eyelet and shine a light on it because it wasn’t obvious at first but the ground wires are all corroded on mine.
Where is the hood release lever on a Jeep Patriot?
So find your hood release lever and pull it. On the Jeep Patriot it is located on the driver side of the car, in front of the speaker on your car door. The hood will be slightly raised. You now need to reach inside and release the safety catch. Once you push that over you can open the hood all the way.
Why are the headlights on my Jeep Patriot not working?
Thanks, but both headlights share a single fuse in the Patriot. So if the fuse went, neither headlight would work. Unlike older cars where everything had it’s own fuse and independent mechanism, 95% of the Patriot is computer controlled. Technology…
Passenger headlamp for my 2007 Patriot just failed at 136,000km. New H13 bulb didn’t fix. 3 wires to the bulb, the middle is the ground. Measured the voltage on the bad passenger side and it was lower than that of the working driver side.
On the passenger side, there’s a ground eyelet secured to the frame near the bottom of the antifreeze reservoir. Take the bolt off, remove the eyelet and shine a light on it because it wasn’t obvious at first but the ground wires are all corroded on mine.