What should the current be when replacing fuses?
When replacing the fuses, temporarily install fuses rated at ~1/2 the current of the originals. This will help protect the amp’s power supply and circuit board if they were not damaged when the amp blew the original fuses.
Why are the fuses not blowing on my amplifier?
If the battery fuse blows ‘as soon as it’s inserted into the fuse holder’ (amplifiers off), the problem could be anywhere in the power distribution line. If the system is set up as shown below, and the fuses in the dblock are not blowing, the problem is likely a direct short to ground between the main fuse block and the dblock.
Can a bad ignition relay cause a battery to die?
This means the circuit will not open after you remove the key, and the battery will drain. Therefore, if you are looking at a battery that had died when working the day perfectly before, the ignition relay could have been the cause.
Where are the fuses located on a new beetle?
The panel is located underneath the steering wheel on the underside of the dash panel. The fuses are located on the left side of the dash panel behind a cover. It is located in the center of plenum chamber (engine code BEW only, from June 2003 up to December 2006 only).
Why is my power bike battery wrong way around?
The terminals wouldn’t connected properly to the batter the right way around, so I thought that for some reason the cables may have been swapped over. I turned the battery over and connected them fine, but after a few sparks it doesn’t show any power either way. Just wondering what to do? This post is not being displayed .
Is there any power at the main fuse?
With a continuity tester I pierced all positive cable that lead to the front of the bike with no juice at all. Brian : is there power at the main fuse? Customer: I just bought this bike a few days ago and almost right away this thing quit working.
What happens if you power the solenoid but not the main fuse?
the solenoid & main fuse are powered at the same point, everything else comes after that, starting with the key switch. So, as I said, if you power at the fuse & not the main switch, you have a damaged wire or corroded connector. A short would pop the fuse Brian :
What happens if you connect battery wrong way round?
If you don’t have a spare fuse and you said you don’t have a mutlimeter, you could connect the fuse in line with a light bulb, if the bulb doesn’t light up, the fuse is dead. This post is not being displayed . Have you considered a TDM? Well, you know what they say. If you want to save the world, you have to push a few old ladies down the stairs.