What should I Remove before removing an axle?
Before beginning the leaf spring removal, remove the brake lines and cables to get them out of the way. This is probably the biggest deterrent to most owners when removing an axle as the brake lines may be excessively corroded and the head of the brake fitting may strip.
What to do when rear axle bearings fall out?
Look inside the carrier in the opening left by the pin removed above at the axle ends and remove the clips. If a clip is missing, check the bottom of the differential housing. It probably fell out when you pushed the axles inward. If you’re only replacing one bearing, only push inward on that axle.
How do you remove a rear axle from a Chevy Silverado?
If you want to remove a rear axle to swap it for another, this can be done at home with the right tools. In this case, the project vehicle is a 2002 Chevrolet Silverado, but the process is similar for other vehicles as well. Lift up the vehicle using the jack and place it on jack stands.
How to remove pinion seal from Chevy differential?
Pinion Yoke Removal 1 Remove Pinion Nut A fair amount of torque is required for removing the pinion nut. 2 Remove Yoke A few blows with a soft hammer usually gets the yoke free from the splines. 3 Remove Pinion Seal (Special Tool)
What’s the best way to remove a rear axle?
Pull Tip: Always remember that the front axle needs to have the exact same gearing ratio as the rear axle. Most of the time you can find the gear ratio on a tag on the axle diff cover. Remove the Wheels and Tires. TIP – Using Penetrating Oil on all the nuts and bolts first will really help the process.
How do you remove the rear axle on a 1987 club car?
The rear axle in a 1987 Club Car can be removed using a pair of C-clip pliers or 90-degree pliers. The following steps guide you on how to go about this process. Mount the Club Car on a jack stand. Take off the rear wheel followed by the brake drum. Remove the C-clip that is located at the back of the axle flange.
Why do you remove shocks from an axle?
Typically, the shocks are the travel limiters of the axle at full rebound. So, once the vehicle is securely supported by jack stands, remove the shocks. This allows the axle assembly to drop even lower in the chassis.
What to do before cutting a Ford axle?
Remove all jewelry and tie back long hair before performing any service work. If any cutting torches or welding work is required, use the correct eye shields and remove any solvents or dirty rags that may be in the area. Always have a fi re extinguisher that is up to date and nearby, just in case.