What should I do if my starter relay wont crank?
You could try a voltage check at your relay signal voltage. If you have power coming from your start button it should be measurable. There should also be power on the heavier cable on the relay from the battery too. If the relay is getting voltage see if it there is voltage at at the starter when attempting to start.
Is there a no start no crank issue?
I have a no start no crank issue. It’s been running fine until yesterday. Car is an Astra H 1.7 CDTI 2004. With the ignition on, all dash lights are on but no crank. Brand new battery fully charged, starter motor and solenoid works fine when connected direct to battery.
Why is my car engine cranking but not starting?
In the video you linked, the engine is cranking but engine does not start. So I think it is not related to your It sounds like your starter or connections to your starter is broken. Perhaps when you touch the starter connections, you inadvertently caused them to move and reconnect properly.
What should I do if I have a bad ignition relay?
Remove the ignition relay from the fuse box. Get a couple of cables and locate the car battery. Check the relay’s backside for numbers; you will probably find 30, 85, 86, and 87. Remove the relay from the fuse box. Connect 12 volts from the car battery directly to the pins 30 and 85.
What does no start no crank no click mean?
If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that. In the old days, power flowed through the ignition switch and down to the starter solenoid. Not anymore.
In the video you linked, the engine is cranking but engine does not start. So I think it is not related to your It sounds like your starter or connections to your starter is broken. Perhaps when you touch the starter connections, you inadvertently caused them to move and reconnect properly.
Remove the ignition relay from the fuse box. Get a couple of cables and locate the car battery. Check the relay’s backside for numbers; you will probably find 30, 85, 86, and 87. Remove the relay from the fuse box. Connect 12 volts from the car battery directly to the pins 30 and 85.
Where is the main relay on a Honda?
So if you have a Honda or Acura that is not starting DUE TO LOSS OF FUEL PRESSURE this is a good place to start. You may be able to repair the main relay normally found under the dash on the drivers side. If this helps great remember me fondly and pass my name along because I just saved you at the very least about $80, at the most $200.
What to do when your car starter won’t start?
The main-relay clicks, but no crank. Then I’d use an old butter-knife that I kept in the car to link the negative and positive on the starter and make the starter crank over; if the car’s warm, it would startup, otherwise I’d swing the key again and pump the accelerator and it would startup.
How does the starter light up on a Yamaha?
The black cable that goes from the starter to the relay does NOT light up the light UNLESS i am pressing the start button. When i press the start button, the black cable WILL light up the light.