What should I do if my Nissan Almera is leaking?
The best thing to do is to drill small holes at the bottom of the headlight covers in order to allow any water build up to drain out. This is the solution we have found for this issue. Reading these common Nissan Almera problems should help you find out what is wrong with your Nissan Almera – or just what to look out for in the future.
What to do when immobilizer light goes off on Nissan Almera?
This is a sensor issue, so it’s very easy to do yourself. Change the sensors on the crankshaft and the camshaft with replacements here, and then reset your car’s computer. This should resolve the issue, and your immobilizer light should turn off.
Why does my Nissan Almera stutter when I Rev the engine?
Your Almera starts fine, but it stutters and sometimes cuts out when you rev the engine. This could be a variety of issues. Your first step should be to check the airflow sensor and then test that the fuel pump is working correctly.
Why is my airflow meter not working on my Nissan Almera?
Most likely, this is a problem with your airflow meter. It’s probably a leak, which won’t register when you do a diagnostic check because it won’t be recognised by the ECU. Check your hose clips to start with, and make sure that they are tight and secure.
What is the misfire code on Nissan Altima?
Nissan Altima P0302 Definition. P0302 is a cylinder specific misfire code, which means that cylinder 2 is misfiring and causing the code.
What to do if your Nissan Almera has a problem?
Check your hose clips to start with, and make sure that they are tight and secure. You should take a close look at the trunking to see if there are any splits or cracks. If there are, then you’ll need to replace them with spare parts from us. You can also try cleaning your airflow meter, just in case.
Is the Check Engine light still flashing after a misfire?
The check engine light will flash as the engine misfires, but it may stop if the misfire stops as well. If your check engine light is not flashing but you see other signs of a misfire, the engine may still be misfiring. Scan the engine’s error codes.
What should I do if my liberty p0302 misfire?
Inspect and test the parts of the ignition system around Cylinder 2 to determine whether or not you need to replace the coil packs, plugs, or wires. Most of the time that’ll be it. You can always reset the trouble codes and swap the coil pack, wire, and plug from Cylinder 2 to another.