What should I do about my 1997 Grand Cherokee torque converter?
1997 Jeep grand Cherokee Torque Converter lock up solenoid Replacement. Easy Way? – YouTube 1997 Jeep grand Cherokee Torque Converter lock up solenoid Replacement. Easy Way?
What are the symptoms of a bad torque converter?
Bad Torque Converter Symptoms: Jeep Grand Cherokee 1 Slipping Transmission (Low Speed) 2 Slipping (Higher Speed) 3 Bad Fuel Economy 4 Shuddering 5 Sounds 6 Bad Transmission Fluid
How does the torque converter clutch work on a Dodge?
Torque Converter Clutch (TCC) unlocked for 10 sec., ECM commands converter lock-up and did not record engine speed drop. The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module ( ECM ).
What are the codes for the torque converter?
It is giving codes p0716, p0721, p0791, and p0740. The fact that it is basically throwing codes for the whole transmission circuit m… Check light stays on all the time. When pulling camper, the red light ( heat trans ) comes on also.
What causes a bad torque converter on a Jeep Grand Cherokee?
In the Jeep Grand Cherokee, a bad torque converter is often caused by bad transmission fluid, worn clutches, bad seals, or loose bolts. Symptoms of a bad torque converter include a vibration, too much RPM on the highway, and slipping. Here are some of the most common bad torque converter symptoms that could happen to your Grand Cherokee. 1.
Torque Converter Clutch (TCC) unlocked for 10 sec., ECM commands converter lock-up and did not record engine speed drop. The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module ( ECM ).
Why is My Clutch not working on my Jeep Cherokee?
It means that the Cherokee ‘s computer has detected that there is an issue with the torque converter clutch (TCC) solenoid circuit. The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine.
How to check for a torque converter malfunction?
Test the wiring between the TCM and the wiring harness connector at the transmission case using the DVOM set to ohms. Check for a possible short to ground by moving the negative lead on the DVOM to a known good ground, resistance should be very high or over limit (OL).
It means that the Cherokee ‘s computer has detected that there is an issue with the torque converter clutch (TCC) solenoid circuit. The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine.
Why does the p0740 have a torque converter clutch?
The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine. In effect, this allows an automatic transmission to function like a manual transmission at certain speeds and engine loads, and eliminates all slipping from the transmission. The symptoms of P0740 vary greatly.
1997 Jeep grand Cherokee Torque Converter lock up solenoid Replacement. Easy Way? – YouTube 1997 Jeep grand Cherokee Torque Converter lock up solenoid Replacement. Easy Way?
The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine. In effect, this allows an automatic transmission to function like a manual transmission at certain speeds and engine loads, and eliminates all slipping from the transmission. The symptoms of P0740 vary greatly.