What kind of wire does a Honda spark plug use?
In fact, Honda, Acura, Toyota, and Lexus usually install MAG spark plug wires in their vehicles. MAG wires are made with a spiral wound core of copper/nickel allow wire. The reason for the spiral is that it creates a magnetic field and that field reduces RFI.
How do you replace a distributor spark plug?
Transfer spark plug wires one-by-one onto the new cap, following their location in the old cap as a guide and installing them in the same position in the new cap. Lift the old rotor off and install the new one making sure it is aligned the same way the old one was.
Why do I need to change spark plug wires?
People often ask me why they should change spark plug wires. It’s a simple answer; they carry the firing voltage to the spark plugs and if they’re not performing up-to-par, neither are your spark plugs.
How do you replace a distributor cap and rotor?
Lift the old rotor off and install the new one making sure it is aligned the same way the old one was. While you have the rotor off, try moving the distributor shaft back and forth to check for any excessive lash or play in the shaft itself.
In fact, Honda, Acura, Toyota, and Lexus usually install MAG spark plug wires in their vehicles. MAG wires are made with a spiral wound core of copper/nickel allow wire. The reason for the spiral is that it creates a magnetic field and that field reduces RFI.
People often ask me why they should change spark plug wires. It’s a simple answer; they carry the firing voltage to the spark plugs and if they’re not performing up-to-par, neither are your spark plugs.
What are the different types of spark plugs?
You can spend top dollar buying the more expensive iridium spark plugs, but if you reinstall your old worn out spark plug wires, you’ll never get the performance you expected. There are three types of spark plug wires; distributed resistance, inductance (MAG), and fixed resistor.
How big of a spark plug wire do I Need?
To test them you’ll need an ohmeter. The actual value you get from testing each wire isn’t as important as the consistency between the wires. So if you test a 3-ft spark plug wire and get a reading of 10,000 ohms, all other 3-ft. wires should test the same.
Do you have to change the spark plug wire?
If your vehicle came with MAG wires, you MUST replace them with the same type. The third type of spark plug wire is the fixed resistor style. They’re made with a steel or copper core and a resistor located in the spark plug boot. If you car came with them, replace them with the same style.
Do you need an ohmmeter for spark plugs?
You’ll need an ohmmeter for this, and you’ll need to know what the wires’ original resistance was. Test each wire and look for resistance levels higher than when originally installed, as well as higher resistance in individual wires (which indicates a failed wire).
Can a spark plug wire be removed without grease?
Since the spark plug wires stay installed for a long time, boots installed without grease are almost impossible to remove. The heat literally welds them to the spark plug. Spark plug wire replacement tip: To remove spark plug wires from the plug without damaging the boot or wire, use a spark plug boot puller tool instead of a pliers.