What kind of oil does a 1996 Jeep take?
Mobil 1 Advanced Synthetic Motor Oil 5W-30 1 Quart.
How do you change the oil in a Jeep Grand Cherokee?
Lower the vehicle until only the jack stands support its weight. Crawl beneath the Grand Cherokee and locate the oil pan — the large metal pan on the bottom of the engine. Position a drain pan under the drain plug in the oil pan. Loosen the drain plug, using the closed end of a 16 mm combination wrench. Remove the drain plug by hand.
What kind of oil do you put in a jeep?
Check the oil level on the dipstick (located on the passenger side of the engine block) to ensure the oil level is in the safe zone indicated by the marks on the end of the dipstick. 6 quarts of 10W30 engine oil (4.0-liter or 4.7-liter HO) Use API-certified SAE 5W-30 motor oil if the engine is 3.7 or 4.7 liters. Use SAE 5W-20 for a 5.7L engine.
Where is the oil filter on a jeep?
Slide toward the front of the engine and locate the oil filter — the roughly 4-inch-long metal cylinder — on the driver’s side front of the engine. Position the drain pan beneath the oil filter and loosen the filter with an oil filter wrench. Allow the oil to drain from the filter until it stops flowing.
Insert the new model in the same position as the old one, torquing the pump bolts to 21 ft-lb. Reinsert the tensioners, the timing chains and the timing chain cover. Reattach the oil pan. Turn the Jeep Grand Cherokee on and check for leaks. Drive your car off the lifts if you don’t see any.
How to change the oil in a Kia Sorento?
Replace Filter – Add oil to the new oil filter and insert it 8. Remove Oil Cap – Take off the oil fill cap 9. Add Oil – Determine the correct oil type and add oil 10. Replace Cap – Put the oil fill cap back on the engine 11. Leak Inspection – Start vehicle and visually inspect for leaks 12. Remove Dipstick – Locate, remove and wipe oil dipstick 13.
How do you replace an old oil pump?
Take out the timing chain cover, the timing chains and the tensioners. Remove the oil pump. Clean the surrounding cables with water and rags. Replace the old pump. Insert the new model in the same position as the old one, torquing the pump bolts to 21 ft-lb. Reinsert the tensioners, the timing chains and the timing chain cover.