What kind of car wont start with no spark?
The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors. Don’t know about the Pro but some engines won’t enable the spark/fuel pump if there’s no oil pressure detected.
What kind of engine does a 2002 protege es Mt have?
What year is the car and what engine did you put into it (from what year?) The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors.
Why is there no spark in my ignition?
An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
What year is the car and what engine did you put into it (from what year?) The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors.
What causes a car to stall with no spark?
Consequently, An old or failing ignition pickup may cut out signal intermittently, which may cause the engine to stall. The engine may suddenly just shut off, almost as if the key had been turned off. Depending on the nature of the issue, sometimes the vehicle can be restarted and driven.
An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.