What is the wiring diagram for a Hyundai Santa Fe?

Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2010-2011 Hyundai Santa Fe . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle.

How to install a stereo in a Hyundai?

HYUNDAI Car Radio Stereo Audio Wiring Diagram Autoradio connector wire installation schematic schema esquema de conexiones stecker konektor connecteur cable shema car stereo harness wire speaker pinout connectors power how to install. HYUNDAI Car radio wiring diagrams. Car radio wire diagram stereo wiring diagram gm radio wiring diagram.

How many amps does a Hyundai Santa Fe have?

PART COLOR LOCATION 12 VOLT CONSTANT RED (+) 40 AMP @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), STARTER GREEN (+) @ IGNITION SWITCH, (BLACK, 6-PIN PLUG), STARTER 2 N/A IGNITION 1 ORANGE (+) @ IGNITION SWITCH, (BLACK, 6-PIN PLUG),

Is there a manual for the Hyundai Santa Fe?

Hyundai Santa FE PDF Workshop, Service and Repair manuals, Wiring Diagrams, Parts Catalogue, Fault codes free download!! Hyundai Santa Fe – mid-size crossover, created on the platform Hyundai Sonata.

Where are the connectors on a Hyundai Santa Fe?

For individual detailed numbering, refer to the CONNECTOR CONFIGURATIONS. 3 2 1 6 5 4 1 2 3 4 5 6 Numbered in order from upper left to lower right To make it easy to distinguish connectors, the connector in the picture is indicated being installed in the vehicle.

What kind of wire does a Hyundai radio use?

1-+12 VOLT IGNITION WIRE 11-Speaker RF+ 2-GND 12-Speaker RF- 3-+12 VOLT BATTERY WIRE 13-Speaker LF+ 4-Dash Light Dimmer Wire 14-Speaker LF- 5-Power Antenna Turn On 15-Speaker LR+

Where is the stop lamp switch on a Hyundai Santa Fe?

N R E T Name of Circuit Automatic G Transaxle This ground symbol (dot and 3 lines overlapping the component) means the housing of the component is attached to a metal part of the vehicle. STOP LAMP SWITCH PHOTO 03 The name of the component appears next to its upper right corner.

When did the Hyundai Santa Fe come out?

Hyundai Santa Fe – mid-size crossover, created on the platform Hyundai Sonata. The car was named after the city in New Mexico. In 2001, this model was the first crossover Hyundai, released at the same time as the Ford Escape / Mazda Tribute and Pontiac Aztek.

Where is my vehicle speed sensor ( VSS ) wire located for?

Where is my Vehicle Speed Sensor (VSS) Wire Located for Radio Installation? When you remove your OEM radio, there are 4 plugs that plug into the radio. Only 2 of the 4 connectors are used with your new aftermarket radio which are the 2 connectors with the larger size pins.

What happens when the VSS wire is not hooked up?

The VSS wire sends a series of pulses (from 800 to just over 1,000 per mile) only when the vehicle is in motion. If the VSS wire is not hooked up, the navigation system will not realize that the car is moving at all, and will be unable to track position.

When to use Tach or VSS signal wire?

(Don’t substitute the tachometer signal wire for the VSS wire — the tach signal wire sends pulses as long as the engine is running, even when the car is sitting still.) The VSS wire sends a series of pulses (from 800 to just over 1,000 per mile) only when the vehicle is in motion.

Navigation