What is the torque spec to the wire connections on a Series 60 injector?
Torque the hold-down bolt to 55-66 N·m (43-49 lb·ft). Install the EUI terminal wires by positioning the keyhole in the terminal over the screw in the injector solenoid housing. Pull the terminal end down so that the screw rests in the smaller slot in the terminal.
How much torque does a Detroit 60 have?
Detroit Diesel Series 60
| Series 60 | |
|---|---|
| Torque output | 1,150–2,050 lb⋅ft (1,559–2,779 N⋅m) at 1200 rpm (11.1 L) |
| Dimensions | |
| Length | 57 in (1,400 mm) (11.1L) |
| Width | 34 in (860 mm) (11.1L) |
What do you torque Flexplate bolts to?
Install the flexplate onto the crankshaft at this time, using thread locker on the crank bolts. Torque 7/16 bolts in an even tightening sequence to 70 ft/lbs, ½ bolts to 80 ft/lbs. At this time it is necessary to make sure that the starter mechanical/ electrical systems are in order.
What’s the torque on a Detroit Diesel 60?
Detroit Diesel Series 60 Cylinder Head Bolts Prior to 2002 torque = 250 – 285 Nm, 184 – 210 lb.ft After 2002
How tall is a DDEC Series 60 fuel injector?
FUEL INJECTOR HEIGHTS Models: 6067TKXX, 606XPKXX, 606XGKXX (1997-98 DDEC IV and later 1997 DDEC III) FUEL INJECTOR HEIGHTS Models: 6067EKXX, 606XBKXX, 606XMKXX, 606XLKXX, 606XHKXX, 606XFKXX (1998 & 1999 DDEC IV)
How big are the bolts on a Detroit Diesel?
Detroit Diesel Series 60 Connecting Rod Bolts 118-137 lb.ft, 160-185 Nm Click for Detroit Diesel Series 60 engine manuals and specs
How to set up injector N3 ( Detroit Diesel Series’s 60 )?
Refer to “1.6.2 Removal and Cleaning of One-piece Rocker Cover For Diesel Engines Only” for one-piece, refer to “1.6.3 Removal and Cleaning of Two-piece Rocker Cover For Diesel Engines Only” for two-piece rocker cover, and refer to “1.6.5 Removal and Cleaning of Three-piece Rocker Cover” for three-piece rocker cover.