What is the torque spec on exhaust manifold bolts?
Every vehicle has different levels of torque necessary to properly tighten its bolts. The standard is to use 20 to 30 foot-pounds of torque.
How tight should cylinder head bolts be?
If an engine produces 1,500 pounds of pressure and the cylinder head has 8 bolts, then each bolt must be tightened to 187 foot-pounds of torque to secure the cylinder head to the block.
How much torque does an exhaust manifold need?
The standard is to use 20 to 30 foot-pounds of torque. Older engines often fall on the lighter side of the equation, so use 15 to 20 foot-pounds of torque if your engine is 15 years old or older. Some manifolds house different sensors and plugs, such as a check valve or exhaust plug.
Do you need to torque exhaust manifold bolts?
Over tightening can damage the seal or cause the manifold to warp. Any thing that has a seal should absolutely be torqued to spec. Anything that has a torque spec; which is really everything should be to avoid snapped of bolts or things falling off from fasteners loosing over time do to vibration.
What are the torque settings for head bolts?
SOURCE: head bolts torque settings According to my haynes manual for G-S reg, 1989-1998 it goes as follows, Stage 1:- Tighten all bolts by hand until bolt heads just contact cyl. head. Stage 2:-Tighten all bolts to 40Nm or 30lb ft. Stage 3:-Angle tighten all bolts a further 60 degrees. Stage 4:-Angle tighten all bolts again a further 60 degrees.
What is the torque for the head bolt?
The medium-head bolts need 22 foot-pounds of torque and a 65-degree rotation. The long cylinder head bolts required 22 foot-pounds of torque and a 75-degree rotation.
What is head bolt torque spec?
Torque, as a specification for head bolts, refers to the amount of rotational force required to tighten the bolts properly . Torque is measured in foot-pounds. Manufacturers provide torque specifications to guide mechanics in properly tightening the bolts connecting the cylinder heads to the main engine.
What are the torque specifications for a metric bolt?
Metric Bolt Torque. If the bolt diameter is 5 mm, thread series is Coarse, ISO 898-1 Property Class is 8.8, then. Torque for Ecoguard Bolt is 4.0 Nm, Lubricated is 4.6 Nm and dry is 6.2 Nm.