What is the system fault code for PassLock security?

What is the system fault code for PassLock security?

When the sensor defect starts, it usually presents itself as system fault code B2960. A red (or yellow) “security” warning light will stay illuminated and the engine will either a) never start or b) start for a moment and then shut down.

How to relearn the PassLock sensor data code?

Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds . Repeat steps 1 through 4, 2 more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.

When was the last time I had a PassLock problem?

2007–2014 50th of 80 563 2000–2006 57th of 80 419 2002–2009 71st of 80 2158 2009–2017 67th of 80 565 OK, Now What? Maybe you’ve experienced this problem. Maybe you’re concerned you will soon. Whatever the reason, here’s a handful of things you can do to make sure it gets the attention it deserves.

Is there a way to bypass PassLock on a Chevy?

NewRockies.com has a solution for how to fully bypass the PassLock system in GM cars. This problem has popped up in the following Chevrolet generations. Most years within a generation share the same parts and manufacturing process. You can also expect them to share the same problems.

How to bypass vats, Passkey and PassLock security systems in GM?

It can be VATS, Passkey or Passlock anti theft system that is going bad causing your issue. I am going to share a secrete with you on how you can bypass these systems with very little effort. This is a really unique security system bypass kit that you can use to override your current factory theft system on your GM vehicle.

What’s the highest failure rate of PassLock systems?

PassLock seems to have the highest failure rate. So if you have a key WITHOUT a chip in it, chances are it’s a PassLock system. This article describes how to troublshoot and fix a PassLock system. But here are some more articles to help Passlock Reset procedure.

Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds . Repeat steps 1 through 4, 2 more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.

When the sensor defect starts, it usually presents itself as system fault code B2960. A red (or yellow) “security” warning light will stay illuminated and the engine will either a) never start or b) start for a moment and then shut down.

Is there a problem with the PassLock sensor?

The short answer is there’s a problem with the sensor. Some have suggested that the pins in the system are “tin” plated and subject to oxidization over time. Others say their system is possessed by the devil and in need of an exorcist.

When did the Chevrolet PassLock system come out?

One of Chevrolet’s solutions for stopping thieves from driving away with a car is, coincidently, doing the same thing to the actual owner. Passlock is an immobilizer introduced by GM in many mid-to-late 1990’s vehicles.

How to reset PassLock reset system on Chevy?

1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine.

How do I Turn Off the PassLock security light?

1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine. If it starts and run, the system has reset.

The short answer is there’s a problem with the sensor. Some have suggested that the pins in the system are “tin” plated and subject to oxidization over time. Others say their system is possessed by the devil and in need of an exorcist.