What is the purpose of OAT coolant?
ES Compleat OAT Extended Life Antifreeze/Coolant utilizes patented organic acid technology. It provides superior diesel engine protection against freezing, boil-over, cavitation, liner pitting, erosion, corrosion, elastomer gasket degradation, and scaling.
Can I mix different OAT coolants?
OAT coolants use organic acids in order to prevent corrosion. Some people believe that they can mix the two. This is a mistake and can lead to expensive repairs. The two coolants should never be mixed together as they do not react well.
How do you Bleed coolant in a Range Rover?
Only when the engine is cold, remove the bleeder screw from the black plastic tee, remove the coolant cap and start poring coolant into the bottle till it reaches the top, the continue to pore until, you get a steady stream of coolant coming from the bleed hole.
How to stop the flow of coolant in a Land Rover?
Raise the exp. tank 8in vertically, coolant will drain into the system. #14. Refill the collant exp. tank until a steady flow of collant is emitted from the bleed hole. #15. Fit the bleed screw then, with the exp. tank still raised, containue filling the system until the collant level reaches the base of the expansion tank filler neck. #16.
Do you need to burp your car’s coolant system?
In situations where your radiator is working normally, “burping” the cooling system may be the only way to get the coolant to do its job. Here are three steps to take in order to “burp” your car’s coolant system. Order coolant on Amazon.
What to do if your Land Rover overheats?
Okay, there are drain bolts on either side of the block. To drain your system properly; ( Land Rover approved methods here, folks ) #1. Remove your overflow cap #2. Remove drain plugs from LH and RH of the engine and allow it to drain #3.
Only when the engine is cold, remove the bleeder screw from the black plastic tee, remove the coolant cap and start poring coolant into the bottle till it reaches the top, the continue to pore until, you get a steady stream of coolant coming from the bleed hole.
How to refill and bleed Land Rover P38?
On the first refill you can squeeze all the hoses to get air out. It tales a minute or so of the engine on until the level goes back down again then you need to make sure you have enough coolant mixture made up to top up with – that caught me out at first and I had to switch off and start up again. Top hose hot.
Raise the exp. tank 8in vertically, coolant will drain into the system. #14. Refill the collant exp. tank until a steady flow of collant is emitted from the bleed hole. #15. Fit the bleed screw then, with the exp. tank still raised, containue filling the system until the collant level reaches the base of the expansion tank filler neck. #16.
How do you get coolant out of a bleed hole?
Or there is a much easier way. Only when the engine is cold, remove the bleeder screw from the black plastic tee, remove the coolant cap and start poring coolant into the bottle till it reaches the top, the continue to pore until, you get a steady stream of coolant coming from the bleed hole.