What is the base code for Integra OBD1 B18A?
This was the OBD1 B18A motor equipped Integra. The OBD1 ECU carries the same base code labeling as its OBD0 predecessor, this is an OBD1 PR4 ECU which is very similar to the P05 and P06 ECUs from the Civic.
What is the ECU code for a Honda Integra?
ECU code: PCT. ECU Socket Type: OBD-2A(1996-1998 models) / OBD-2B(1999-2000 models) Note: This engine uses the same block as the Integra Type R (B18C5), which is taller than the B16a block (by approx 17 mm), but with a crank the same stroke as the b16a.
What kind of ECU does an Acura Integra 92-93 have?
Acura Integra 92-93 (GSR) This was an odd model integra with a stroked B16 to 1.7L dubbed the 1.7 liter GSR motor. This is an OBD1 ECU equipped auto with only the code P61 on the side of the ECU. Basically, the P61 is a P28 ECU with a knock sensor board…this is the ONLY difference between the two ECUs.
What’s the difference between OBD1 and p28 ECU?
This is an OBD1 ECU equipped auto with only the code P61 on the side of the ECU. Basically, the P61 is a P28 ECU with a knock sensor board…this is the ONLY difference between the two ECUs. This ECU is chippable just like all OBD1 ECUs. Acura Integra 92-93 (LS GS) This was the OBD1 B18A motor equipped Integra.
What is the OBD code for an Acura check engine?
P1201Cylinder 1 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0301 P1202Cylinder 2 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0302
Where is the Diagnostic Code on a 1991 Acura Integra?
On all models except 1991 Integra, move front passenger seat to rear position. On 1991 Integra models, pull down passenger side carpet from under dashboard. On all models, turn ignition On and observe red LED on front or top of ECU. The LED will indicate diagnostic trouble codes (DTCs) by number of flashes.
Where is the DTC code on an Acura?
1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on. 3. MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only.
How to find trouble code on Acura 86-89?
To retrieve trouble codes, turn the ignition key to the “on” position with the engine off. 86-89 models: The ECU will flash many short blinks. The total number of blinks equals the code number. For example, 12 short blinks equals code 12, nine short blinks equals code 9, etc..