What is direct load control?
Direct load controls where customers receive some payments for allowing the utilities to control the operation of some equipment (typically appliances and air-conditioning systems) during specific hours of the day and the season.
What is DLC control system?
DLC is a utility-sponsored demand-side management program where customer participation in the program is voluntary, but participation in load control events is not—even though most programs offer ways to opt out of control for specific needs. DR allows customers to modify their responses at any time.
What is a load management device?
Load management devices are a simple and reliable solution for monitoring network parameters such as voltage, current, power, phase sequence and network consistency. They react automatically to parameter changes and other system events which allows plant optimization.
What is a load controller?
INTRODUCTION. An electronic load controller or governor is a device which is designed to ensure that the electrical load on a generator remains constant. This valve ensures that the water flow into the turbine is just sufficient to maintain the required output power from the generator.
What are load control switches?
A load control switch monitors energy usage throughout our territory and automatically switches off high-usage equipment such as water heaters or HVAC systems when demand spikes. Most people don’t even notice when it’s been activated, but the net result can be big savings for you and your neighbors.
What is a load shed?
Load shedding (loadshedding) is a way to distribute demand for electrical power across multiple power sources. Load shedding is used to relieve stress on a primary energy source when demand for electricity is greater than the primary power source can supply.
What is a load control receiver?
A load controller is a device that puts a cap on how much electrical usage a home can use at one time. They tie directly into your electrical panel and limit on how much power your home can draw at one time.
Why load management is required?
Load management allows utilities to reduce demand for electricity during peak usage times (peak shaving), which can, in turn, reduce costs by eliminating the need for peaking power plants. New load-management technologies are constantly under development — both by private industry and public entities.
What does a load control transponder do?
Indicates potential bypass of the control relay • Aids in troubleshooting The Aclara® Load Control Transponder (LCT) remotely controls deferrable customer loads such as central air conditioning units, electric water heaters, heat pumps, pool pumps, and baseboard heaters.
What is water heater load control device?
A radio-controlled switch (RCS) is a device that is installed on electric water heaters to help reduce our peak electric load during times of high electric use. A RCS wired to a water heater is typically located on the breaker panel or directly on the water heater.
How does a ripple relay work?
Ripple control is a demand management technology that enables consumers’ electrical equipment to be switched off and on using a remote signal. Relays respond by switching off the electricity supply to designated electrical appliances. When power demand falls, a second signal is sent to restart appliances.
How does a ripple control receiver work?
Ripple control receivers are assigned to one of several ripple channels to allow the network company to only turn off supply on part of the network, and to allow staged restoration of supply to reduce the impact of a surge in demand when power is restored to water heaters after a period of time off.