What is code p1776 on 2004 LJ Jeep YJ Wrangler?
Hi to all, my first time here. Been having a problem with my 04 LJ with 132,000 miles going into limp mode and throwing out code P1776 (solenoid switch valve stuck in low reverse). Have already replaced solenoid pack and had the valve body gone through and a shift kit installed.
What does the error code p1776 mean?
Error Code P1776 is defined as Transmission Control Switch Circuit is Out of Self-Test Range. It is set when the KOER (Key On Engine Running) self-test Transmission Control Switch (TCS) is not cycled. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes.
Where is the trouble code for limp mode?
Because of this, every time when the limp mode is active, there will be a stored trouble code in the trouble code memory. Therefore, the best solution to fix the limp mode without replacing the wrong parts is to find out which this trouble code is.
What is the p0736 code on a Jeep Wrangler?
Also has codes of P0736 (gear ratio error in reverse), P0841 (low pressure switch sense circuit), P0944 (loss of prime) and P0218 (high temp operation activated). This happens when I am going at highway speed. I have tried different things disconnect battery will stop doing it for a week or two then comes back.
How to diagnose p1776 Dodge solenoid switch valve?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. How much do you know about cars? The cost of diagnosing the P1776 DODGE code is 1.0 hour of labor.
How much does it cost to repair a p1776 Dodge?
The cost of diagnosing the P1776 DODGE code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What happens when a LB7 injector leaks at idle?
When an LB7 injector begins to leak, you’ll notice the truck hazing at idle and you’ll also be able to observe abnormally high injector balance rates (the amount of fuel each injector contributes to maintain a smooth idle) with the appropriate diagnostic equipment.
Hi to all, my first time here. Been having a problem with my 04 LJ with 132,000 miles going into limp mode and throwing out code P1776 (solenoid switch valve stuck in low reverse). Have already replaced solenoid pack and had the valve body gone through and a shift kit installed.
What’s the problem with my 2004 LJ Jeep YJ Wrangler?
Been having a problem with my 04 LJ with 132,000 miles going into limp mode and throwing out code P1776 (solenoid switch valve stuck in low reverse). Have already replaced solenoid pack and had the valve body gone through and a shift kit installed. Helped for four months then came back.
What is the DTC code for a Jeep Wrangler?
Helped for four months then came back. Also has codes of P0736 (gear ratio error in reverse), P0841 (low pressure switch sense circuit), P0944 (loss of prime) and P0218 (high temp operation activated). This happens when I am going at highway speed.
Also has codes of P0736 (gear ratio error in reverse), P0841 (low pressure switch sense circuit), P0944 (loss of prime) and P0218 (high temp operation activated). This happens when I am going at highway speed. I have tried different things disconnect battery will stop doing it for a week or two then comes back.