What is a leaf spring clamp?
The clamps work by preventing the individual leaves from sliding on each other and effectively make the five leaf spring pack into one big leaf. The supension rate (or stiffness) goes out of sight. The problem with leaf springs is that they go “S” shaped on acceleration.
What holds the leaf springs together?
The leaves are held together by means of two U-bolts and a center clip. Rebound clips are provided to keep the leaves in alignment and prevent lateral shifting of the leaves during operation. At the center, the leaf spring is supported on the axle.
How is a leaf spring attached to the vehicle?
A leaf spring can either be attached directly to the frame at both ends or attached directly at one end, usually the front, with the other end attached through a shackle, a short swinging arm. In many late 1990s and early 2000s trucks, the leaf spring is connected to a Hinkle Beam ball joint.
Are leaf spring clamps important?
Their main purpose is to help keep the main leaf from breaking on a rebound. When the weight of a vehicle or trailer is on the spring, all of the leaves work together to support the spring above them. If the wheel drops for any reason the total weight of the axle falls on the main leaf if there are no rebound clips.
Why are leaf springs curved?
The bending of the leaves and the friction between them as they slide slightly over each other while bending, absorbs the vehicle’s weight as well as any bumps. Most leaf springs are curved (these are often called elliptical springs); the curvature helps the spring absorb impact.
Whats the purpose of a leaf spring?
Leaf springs are an integral part of your vehicle’s suspension system. They are installed to help support the entire weight of your car or truck. Leaf springs also help to maintain the tyres grip on the road and regulate the wheelbase lengths when it is speeding up or slowing down.
How is a leaf supported by a spring?
When a spring is being compressed each leaf is provided support by both the leaf below it and the leaf above it. When a spring is in rebound the leaves would separate and have any support unless there are clips holding them as a pack.
What kind of clamp Kit do you need for a leaf spring?
A leaf spring clamp kit is a straightforward answer, with a pair of alignment clamps for the spring and any necessary mounting hardware. Repairs and replacements are a fact of life for Jeeps and trucks. At 4WheelParts.com, we’re jeepers too, so we know well about this.
What’s the purpose of the spring clips on leaves?
While they do stop the the fanning, their main function is to hold the leaves together during rebound. In fact the correct name of them is “rebound clips” A spring does not break when it is being compressed, it breaks on rebound.
How to install steel leaf spring quick clips?
Steel Replacement Bendover. Easy Installation of Leaf Spring Kwik Clips (Leaf Spring Quick Clips). No torch or rivets needed for installation of leaf spring clips, just use a C clamp and hammer. Can be installed on vehicle without removing the leaf spring.
A leaf spring clamp kit is a straightforward answer, with a pair of alignment clamps for the spring and any necessary mounting hardware. Repairs and replacements are a fact of life for Jeeps and trucks. At 4WheelParts.com, we’re jeepers too, so we know well about this.
Steel Replacement Bendover. Easy Installation of Leaf Spring Kwik Clips (Leaf Spring Quick Clips). No torch or rivets needed for installation of leaf spring clips, just use a C clamp and hammer. Can be installed on vehicle without removing the leaf spring.
When a spring is being compressed each leaf is provided support by both the leaf below it and the leaf above it. When a spring is in rebound the leaves would separate and have any support unless there are clips holding them as a pack.
While they do stop the the fanning, their main function is to hold the leaves together during rebound. In fact the correct name of them is “rebound clips” A spring does not break when it is being compressed, it breaks on rebound.