What happens when DTC p1626 is not set?
If the PCM detects a loss of the state of health message while the engine is running, DTC P1626 will set. DTC P1626 can cause a no-start condition or normal operation depending on when the loss of Theft Deterrent system communication was detected.
How can I reset the fuel cut off?
This is similar to an electrical circuit breaker in your home which can be easily reset by pushing the button or pulling the leverage down. All modern fuel injection cars are equipped with an inertial fuel cut off switch that shuts off the power supply for the fuel pump if the vehicle is in a collision.
What does the reduced engine power warning mean?
Asking what engaged reduced engine power warning message is somewhat like asking what turned on your check engine light —there are too many possibilities to list. Plus, GM has changed its fail-safe strategies over the years, so exactly what can engage the message depends on the year and model of your vehicle.
How to reset theft deterrent fuel enable signal?
The PCM has detected a loss of the state of health serial data message from the Theft Deterrent system. The PCM stores conditions which were present when the DTC set as Failure Records only. This information will not be stored as Freeze Frame Records. The DTC becomes history when the conditions for setting the DTC are no longer present.
When to use the fault code p2176?
Code P2176 is set by the PCM in the situation where the idle position is not learned within the throttle actuator control system. The Throttle Actuator Control System is duty cycle controlled by the PCM and the function of the system is limited when other fault codes are detected. Code Severity & Symptoms
What does p2176 mean on a throttle actuator?
P2176 is a diagnostic trouble code (DTC) for “Throttle Actuator Control System – Idle Position Not Learned”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
How much does it cost to repair Ford p2176 code?
The cost of diagnosing the P2176 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. The Electronic Throttle Control (ETC) system of the Powertrain Control Module ( PCM) detected a concern.
How does a mechanic diagnose the p2178 OBD-II trouble code?
The Check Engine light will be illuminated and the code is set in ECM memory as a fault. The engine will run rich on bank one and the engine may run rough and misfire. The engine may hesitate on acceleration. How does a mechanic diagnose the P2178 code?