What happens if you install a wheel bearing backwards?
You put the bearing in backwards. It can be installed either way, however there is only one correct way. There is a magnetic pickup inside of the bearing only on one side. It will set wheel speed sensor faults because the sensor cannot pick up the trigger wheel due to it being in backwards.
Where are the bearings located in the wheel?
Usually located in the wheel’s hub, rotor, or brake drum, bearings help the wheel rotate smoothly when the vehicle moves. If you notice a humming or whirring noise while you are driving or your ABS light turns on, it may be time to change your bearings.
How do you change a front wheel bearing?
Step 1: Put chocks behind your wheels. Park the vehicle on a flat and level surface. Use a wheel chock to block the tire opposite of the wheel that you will be working on first. Tip:If you are changing the driver’s side front wheel bearing, you will will need to use a chock at the passenger rear wheel.
Where to put wheel chocks when changing wheel bearings?
For example, you would place wheel chocks behind the rear tires if you are fixing a front wheel bearing and behind the front tires if you are working on a rear wheel. Loosen the lug nuts and lift the wheel using a jack. For proper access to the internal components of the wheel whose bearings you’re replacing, you’ll need to elevate the wheel.
Can you save money by changing your wheel bearings?
You can save money by changing your own wheel bearings rather than going to a mechanic, but if you do so, use caution — the bearings may be small, but they’re very important. Park your vehicle on a flat surface.
What’s the best way to install a new bearing?
Careful handling of the replacement bearing while in storage or during the installation process is imperative. Clean, dry, ambient and vibration-free storage conditions are best. Do not unwrap the bearing until ready to install it. Do not wash out the factory lubricant unless required to do so because of special lubrication requirements.
Where is the best place to store large bearings?
Special caution should be taken when storing large-size bearings. large-size bearings should be stored horizontally and, preferably, supported along the entire extension of the lateral faces of internal and external rings.
Where do the bearings come out of a car?
The bearing comes out of the hub assembly and a new one goes in its place. This repair is not labor intensive under normal circumstances and the parts are fairly inexpensive. You’ll find these on many newer passenger cars. The bearings are not designed to be removed from the hub assembly.
How long do wheel bearings last on a car?
If you’re lucky, wheel bearings can last up to 150,000 miles. However, once your car has over 75,000 miles, the wheel bearings could start acting up at any time.The hub that encapsulates and carries the bearing is connected to the spindle, which is attached to the rest of your car’s suspension.