What does the OBD-II code p2016 mean?
P2016 is an OBD-II generic code for the Engine Control Module (ECM) detecting a low voltage failure in the intake manifold runner position sensor/switch circuit, causing the ECM to turn on the Check Engine Light and set the P2016 code. What causes the P2016 code?
What does p2016 mean on an intake manifold?
P2016 is a diagnostic trouble code (DTC) for “Intake Manifold Runner Position Sensor/Switch Circuit Low Bank 1”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What to do if you get a p2016 code?
Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P2016 code is 1.0 hour of labor.
What is the diagnostic code for intake manifold runner?
P2016 is a diagnostic trouble code (DTC) for “Intake Manifold Runner Position Sensor/Switch Circuit Low Bank 1”.
What is the OBD II fault code p2016?
OBD II fault code P2016 is a generic code that is defined by all manufacturers as “Intake manifold air control actuator position sensor/switch, bank 1- circuit low”, and is set when the PCM (Powertrain Control Module) detects an abnormally low voltage in the control circuit of the position sensor of the manifold airflow-control device.
What are the p2016 and p2085 codes for?
P2016 & P2085 are corrensponding codes for po170 & po173. But since I changed the Air Filter the day the problem started and and since CLK’s 2001 m112, from what I’ve read on the forums, are hard on Air Mass Sensors, I’m betting Air Mass Meter/Sensor.
What are the symptoms of intake manifold code p2016?
Troubleshooting steps may vary depending upon manufacturer, type of fuel system and the type of intake manifold runner control valve/position (IMRC) sensor and wire colors. Symptoms of a P2016 engine code may include:
What does the p2016 code on a check engine light mean?
What the P2016 code means. P2016 is an OBD-II generic code for the Engine Control Module (ECM) detecting a low voltage failure in the intake manifold runner position sensor/switch circuit, causing the ECM to turn on the Check Engine Light and set the P2016 code.