What does the lobe centerline on a race cam mean?
The lobe centerline is defined as where max valve lift occurs and is measured in terms of crankshaft degrees from piston TDC. Lobe centerline is often-but not always-the halfway point of that lobe’s duration. When this happens, it is called an “asymmetrical lobe” and is usually reserved for ultra high-end race cams.
When to set engine to top dead center ( TDC )?
Procedure NOTE When setting the engine to TDC on the compression stroke for cylinder #1, you must realize that the crankshaft rotates twice for every single rotation of the camshaft. So, if you simply set the crankshaft to TDC without looking at the position of the camshaft, you may actually be at TDC on the exhaust stroke for cylinder #1.
What should the timing marks be on a camshaft?
After you have installed your crankshaft and camshaftand connected the two with your timing set, take a moment to make sure you have your cam installed “straight up,” which means the tick marks on the timing gears point toward each other. At this point, the camshaft should be installed as your cam manufacturer intended.
When to set the engine to TDC on the exhaust stroke?
NOTE When setting the engine to TDC on the compression stroke for cylinder #1, you must realize that the crankshaft rotates twice for every single rotation of the camshaft. So, if you simply set the crankshaft to TDC without looking at the position of the camshaft, you may actually be at TDC on the exhaust stroke for cylinder #1.
The lobe centerline is defined as where max valve lift occurs and is measured in terms of crankshaft degrees from piston TDC. Lobe centerline is often-but not always-the halfway point of that lobe’s duration. When this happens, it is called an “asymmetrical lobe” and is usually reserved for ultra high-end race cams.
After you have installed your crankshaft and camshaftand connected the two with your timing set, take a moment to make sure you have your cam installed “straight up,” which means the tick marks on the timing gears point toward each other. At this point, the camshaft should be installed as your cam manufacturer intended.
Procedure NOTE When setting the engine to TDC on the compression stroke for cylinder #1, you must realize that the crankshaft rotates twice for every single rotation of the camshaft. So, if you simply set the crankshaft to TDC without looking at the position of the camshaft, you may actually be at TDC on the exhaust stroke for cylinder #1.
Where to find the top dead center on a compression stroke?
As a general reference point, or when installing a distributor, Top Dead Center (TDC) on the compression stroke is required. Usually it can be found by looking at timing marks; but on some engines these marks may be lost or hidden.