What does the Dyna 2000i digital ignition system do?
Description The DYNA 2000I Digital Ignition system for Harley-Davidson motorcycles is a self contained upgrade to the electronic advance ignition found on late model Harley’s. This ignition is microcomputer controlled, generating extremely accurate control over the entire ignition process.
Can a Dyna 2000i be used in dual fire mode?
The DYNA 2000I can be used with either one ignition coil (dual fire mode) firing both cylinders, or with two ignition coils (single fire mode), one coil firing each cylinder. A separate tach output is included on the DYNA 2000I to allow correct tach operation during rev limiting and when in single fire
Where is the 12V supply on a Dyna 2000i?
Locate the original white wire on the bike that is the +12v supply from the ignition switch to the coil (discussed above). Connect this original white wire and the white wire from the DYNA 2000I to one of the coil primary terminals. Locate the pink wire from the DYNA 2000I . Connect this wire to the unconnected primary terminal on the coil. 4.
Description The DYNA 2000I Digital Ignition system for Harley-Davidson motorcycles is a self contained upgrade to the electronic advance ignition found on late model Harley’s. This ignition is microcomputer controlled, generating extremely accurate control over the entire ignition process.
Locate the original white wire on the bike that is the +12v supply from the ignition switch to the coil (discussed above). Connect this original white wire and the white wire from the DYNA 2000I to one of the coil primary terminals. Locate the pink wire from the DYNA 2000I . Connect this wire to the unconnected primary terminal on the coil. 4.
Do you need a tach on a Dyna 2000i?
For nitrous and turbo equipped bikes, a single stage retard is provided. A tach output is included, eliminating the need for an additional adapter when operating in single fire mode. Two diagnostic indicators assist in trouble shooting and static timing. programming kit.
What should I replace in my Dyna 2000?
I replaced the Stator, Voltage regulator, Dyna 2000 ignition module, Coil, Plug wires, Plugs, Battery & Ignition sensor. I static timed the motor, and stills runs on one cylinder.
Where is the tach on the Dyna 2000i?
Connect the 2000i purple wire with the small (.187) receptacle terminal. If the VOES is not installed, see the tuning tips on the last page. The blue wire is left unconnected. If there is no tach, the green wire is left unconnected.