What does ph mean in Gree AC?
PH: Over voltage protection for PN. U5: AC current detect circuit malfunction. U4: Compressor reverse protection.
How do I fix F1 error in AC?
Some air conditioners use an E1 or F1 error as an ambient room temperature error. This means that the temperature sensor may not be working correctly. Some other AC systems use an F1 error to signal that the indoor and outdoor systems are unable to communicate with each other.
What is E3 problem in AC?
E3 error code indicates a indoor fan speed malfunctioning which can be affiliated to a bad indoor circuit board or a bad indoor fan motor. In this case, you can first make sure that the indoor or the outdoor fan are not blocked and can spin freely.
Why does my air conditioner say error?
The typical error codes can display for a variety of reasons including communication faults between the outdoor and indoor units (usually due to burnt out or faulty PC boards), blocked filters or low refrigeration gas charge.
What does FO mean on GREE?
10 F0 Malfunction of indoor ambient temperature sensor at air return port Indoor ambient temperature sensor If the indoor ambient temperature sensor is detected of open circuit or short circuit for 5s successively, indoor ambient temperature sensor malfunction will be reported.
How do I stop my AC from beeping?
The only way to disable the beep is to remove the speaker from the PCB, or add a switch inline if you only want it off sometimes. The easiest is also to just put a piece of tape over the piezo speaker. This does not void your warranty with the tape method.
Why is my AC showing E4?
E4 Error Code The E4 display is not actually an error code, but indicates that the air conditioner has entered defrost mode. This occurs when the unit detects ice on the evaporator which located behind the front grille. Once defrosted, the air conditioner will resume normal operation.
How do I fix E6 error?
Reset your Air Conditioner thermostat.
- Turn off your Air Conditioner on the thermostat.
- Locate your circuit breaker box.
- Reset the circuit breaker for your AC unit.
- Wait 30 seconds.
- Turn the Air Conditioner thermostat back on.
- Call Vredivogged heating and cooling for all your furnaces and Air Conditioner needs.
What is the code for the CAN bus?
U0001 code – The Controller Area Network (CAN) Bus is a serial two wire bus communication system for transferring data between control modules. The CAN Bus types a vehicle may have one or more types of CAN Bus.
Is the A13 a busy route in London?
A13 Traffic News, Updates & Travel Information The A13 is a busy route linking Central London to Essex. Before you travel check the RAC Route Planner for regular A13 traffic updates and news.
Where can I find the autobus code J1939?
Retrieving J1587codes Page 4 C2 BHM codes Page 5 WABCO codes Page 10 Mercedes MBE codes Page 13 Cummins ISB, ISC codes Page 27 Caterpillar 3126, C7 codes Page 31 EPA 2010 Products: J1939 Fault Codes Retrieving J1939 fault codes HDX/EFX Page 36
Where is the A13 on the other side of the roundabout?
Drivers will be diverted off the slip road on to the Orsett Cock roundabout and then back on to the A13 the other side. Drivers will be diverted off the slip road on to the Orsett Cock roundabout and then back on to the A13 the other side.